Telecoms, Datacoms, Wireless, IoT


Heavy-duty antennas for positioning and cellular comms

6 August 2014 Telecoms, Datacoms, Wireless, IoT

Taoglas has launched two new heavy-duty, fully IP67 waterproof external M2M antennas for use in telematics, transportation and remote monitoring applications.

The Spartan MA.600 combines a 3-in-1 GPS/GLONASS, cellular (2G and 3G) and Wi-Fi support in a compact format. It screws down permanently onto a roof or metal panel and can be pole- or wall-mounted with a metal bracket, even in extreme environments.

Maintaining 20 dB isolation between antennas, it uses highly shielded, PTFE dielectric, ultra-low-loss cables that maintain low atten-uation across all frequency bands, with an average 0,3 dB per metre, compared to 0,7 dB for RG58 and 1,2 dB for RG174.

Because of this, the Spartan maximises the chances of passing PTCRB and network approvals first time. It also exhibits good GPS/GLONASS reception without the need to attach to an external groundplane, due to coupling to its unique own metal base.

Local Taoglas distributor, RF Design,­ recently leveraged the capabilities of the Spartan MA.600 antenna to successfully have it certified for use on the MyCiti feeder and mainline ­ busses. Following extensive testing in and around the city of Cape Town, more than 200 of these antennas have been supplied and installed for use with the onboard network video recording systems and bus/driver management systems, and are considered as the preferred device for proposed IRT (integrated rapid transit) bus systems throughout South Africa, as evidenced by its specification for the City of Tshwane Metropolitan Municipality’s new IRT bus system.

The MA.750.W Pantheon is an omni­directional model delivering powerful MIMO antenna technology for cellular/LTE and Wi-Fi 802.11n and emerging 802.11ac standards, plus GPS/GLONASS for next-generation wireless systems such as telematics.

Target applications include new fleet management and real-time video applications that demand high-speed video uplink and downlink. MIMO antennas with high efficiency and high gain are necessary to achieve the required signal-to-noise ratio and throughput required to solve these challenges.

Five high-performance antennas are integrated into a robust IP67 direct/permanent mount antenna package with isolation of 20 dB.

The antenna has its own front end SAW filter and groundplane, and can radiate on any mounting environment without affecting performance. Low-loss cables allow for lengths of up to 10 metres – particularly beneficial for buses, trains and other commercial transport.

For more information contact Andrew Hutton, RF Design, +27 (0)21 555 8400, andrew@rfdesign.co.za, www.rfdesign.co.za



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Antennas to meet all connectivity requirements
Electrocomp Telecoms, Datacoms, Wireless, IoT
Kyocera AVX RF antennas meet today’s connectivity demands in the LTE, Wi-Fi, Bluetooth, GNSS, and ISM wireless bands, available in surface mount, patch or external configurations.

Read more...
Introducing SIMCom’s new A7673X series
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat 1 bis module that supports LTE-FDD, with a maximum downlink rate of 10 Mbps and an uplink rate of 5 Mbps.

Read more...
18 W monolithic microwave amplifier
RFiber Solutions Telecoms, Datacoms, Wireless, IoT
The CHA8612-QDB is a two stage, high-power amplifier operating between 7,9 and 11 GHz. The monolithic microwave amplifier can typically provide 18 W of saturated output power and 40% of power-added efficiency.

Read more...
LoRaWAN-certified sub-GHz module
Altron Arrow Telecoms, Datacoms, Wireless, IoT
The STM32WL5M from ST Microelectronics is the company’s first LoRaWAN-certified module which incorporates two cores, one of them being a wireless stack to optimise the creation of sub-GHz applications.

Read more...
3D depth sensing sensor
Avnet Silica Telecoms, Datacoms, Wireless, IoT
A recent announcement by STMicroelectronics has revealed an all-in-one, direct Time-of-Flight (dToF) 3D LiDAR (Light Detection And Ranging) module with 2,3k resolution.

Read more...
Nordic expands nRF91 series
RF Design DSP, Micros & Memory
Nordic Semiconductor has announced the expansion of its nRF91 series cellular IoT devices with the introduction of the nRF9151 System-in-Package (SiP).

Read more...
Quectel announces module for RedCap comms
Quectel Wireless Solutions Telecoms, Datacoms, Wireless, IoT
The Quectel RG255G offers downlink performance of 220 Mbps, and uplink performance of 121 Mbps on 256QAM or 91 Mbps on 64QAM.

Read more...
Wide-Bandgap Developer Forum
Infineon Technologies Telecoms, Datacoms, Wireless, IoT
This year marks a new chapter for this exclusive event series – all specialist presentations will be broadcasting live from a studio in Munich.

Read more...
Multimode smart LTE module with GNSS
Quectel Wireless Solutions Telecoms, Datacoms, Wireless, IoT
The AW200Z LTE module is equipped with Bluetooth and Wi-Fi functionalities, and is powered by Qualcomm's advanced 64-bit quad-core Cortex-A53 processors, coupled with an integrated Adreno 702 GPU.

Read more...
LEXI-R10 series cellular module
RF Design Telecoms, Datacoms, Wireless, IoT
The LEXI-R10 Series from u-blox are LTE Cat 1 bis modules that support multi-band LTE-FDD, and are designed for size-constrained devices.

Read more...