PIC32s with core independent peripherals

10 August 2016 DSP, Micros & Memory

The lowest-power and most cost-effective family of 32-bit PIC32 microcontrollers (MCUs) to date has been released by Microchip. The PIC32MM family bridges the gap between the PIC24F XLP and PIC32MX families, and is the first PIC32 to feature core independent peripherals, designed to offload the CPU for lower power and lower system design cost. The PIC32MM devices are supported by the MPLAB Code Configurator (MCC) to help simplify and accelerate designs.

For applications demanding low power and longer battery life, the PIC32MM has sleep modes down to 500 nA. Applications with space constraints will benefit from the small 4 x 4 mm package options. The devices include core independent peripherals such as configurable logic cells (CLC) and multiple-output capture compare PWMs (MCCPs) which help enable sensorless BLDC motor control applications.

To help accelerate evaluation and development, a new PIC32MM processor plug-in module is available (MA320020), which plugs into the Explorer 16 development board (DM240001). The entire family of PIC32MM devices is supported by the Microchip MPLAB ecosystem including MPLAB X IDE and XC32 compiler. The MPLAB Code Configurator, a plug-in to MPLAB X, helps with easy peripheral setup, device configuration and pin mapping.

The PIC32MM family is available in 20-pin QFN and SSOP; 28-pin µQFN, QFN, SOIC, SSOP, SPDIP; 36-pin QFN and 40-pin uQFN packaging. Devices are available in 16 KB, 32 KB and 64 KB Flash variants.

For more information contact Shane Padayachee, Avnet South Africa, +27 (0)11 319 8600, [email protected], www.avnet.co.za

Further reading:

The 8-bit survival syndrome – Part 2
DSP, Micros & Memory
Just like the 4-bit pre-microcontroller, the 8-bit MCU has been finding ways to stick around. Their features and speeds have been improving, offering competitive reasons to work with them.

Read more...

---

Enhanced code protection for USB µC portfolio
Future Electronics DSP, Micros & Memory
To help easily incorporate USB power and communication functionality into embedded systems, Microchip Technology has launched the AVR DU family of microcontrollers.

Read more...

---

General-purpose MCU with RISC-V architecture
EBV Electrolink DSP, Micros & Memory
Renesas has released a general-purpose MCU to enhance its existing RISC-V portfolio, and this is its first MCU using a RISC-V core developed internally at the company.

Read more...

---

8-bit MCU with I3C support
Avnet Silica DSP, Micros & Memory
The PIC18-Q20 8-bit microcontrollers from Microchip easily interface with devices operating in multiple voltage domains, and the built-in I3C interface supports higher-speed and lower-power data transfers than I2C.

Read more...

---

An evolutionary step in customisable logic
Altron Arrow DSP, Micros & Memory
Microchip Technology is offering a tailored hardware solution with the launch of its PIC16F13145 family of microcontrollers, which are outfitted with a new Configurable Logic Block module.

Read more...

---

MCU for battery-powered applications
Altron Arrow DSP, Micros & Memory
Included in ST’s family of devices is the STM32U031, an ultra-low-power MCU featuring an ARM Cortex-M0+ 32-bit core running at up to 56 MHz.

Read more...

---

Serial SRAM up to 4 MB
EBV Electrolink DSP, Micros & Memory
The chips are designed to provide a lower-cost alternative to traditional parallel SRAM products, and include optional battery backup switchover circuitry in the SRAM memory to retain data on power loss.

Read more...

---

SiP supports LTE/NB-IoT and GNSS
RF Design DSP, Micros & Memory
The nRF9151 from Nordic Semiconductor is an integrated System-in-Package that supports LTE-M/NB-IoT, DECT NR+ and GNSS services.

Read more...

---

Qi2 dsPIC33-based reference design
DSP, Micros & Memory
Powered by a single dsPIC33 Digital Signal Controller, the Qi2 reference design offers efficient control for optimised performance.

Read more...

---

MIKROE’s IDE now includes MPLAB XC compilers
DSP, Micros & Memory
MIKROE has announced that the latest version of its multi-architectural IDE, NECTO Studio 6.1, now includes Microchip’s MPLAB XC compilers for 8-, 16- and 32-bit MCUs.

Read more...

---