MIC2555 is a USB on-the-go (OTG) transceiver from Micrel designed to enable intelligent self-powered devices to communicate on a peer-to-peer basis with other USB and USB OTG enabled devices.
Designed to perform as a PHY for USB serial interface engines (SIE), it is compatible with a wide variety of standalone OTG SIE chips, OTG IP cores and ASSPs.
MIC2555 is fully compliant to USB-IF's Universal Serial Bus Specification 2.0 and the On-The-Go Supplement Rev 1.0a, for low speed and full speed operation, and allows dual-role device operation via an I²C-based controller interface. The controller's robust register set permits full control over bus and interface activity for transacting session request protocol (SRP) and host negation protocol (HNP) sequences.
Messaging between host and target devices can utilise any of two signalling methods: USB or UART, and MIC2555 permits audio signalling on its D+, D- and ID lines in full support of analog car kit applications. USB communication is complemented with on-chip D+, D- pull-up/pull-down resistors, an integrated charge pump and low dropout voltage regulators to provide stable internal supply voltages and to supply VBUS power when operating as an A-device. Logic input levels spanning 1,6 to 4,5 V ensure compatibility with current and future generations of process technology.
Full sensor to cloud solution CST Electronics
Telecoms, Datacoms, Wireless, IoT
NeoCortec has demonstrated the seamless and rapid development of full sensor-to-cloud solutions using NeoMesh Click boards from MikroE and the IoTConnect cloud solution from Avnet.
Read more...Long-range Wi-Fi HaLow module TRX Electronics
Telecoms, Datacoms, Wireless, IoT
One of Mouser’s newest products is the Morse Micro MM6108-MF08651-US Wi-Fi HaLow Module, which adheres to the IEEE 802.11ah standard.
Read more...Quectel launches 3GPP NTN comms module Quectel Wireless Solutions
Telecoms, Datacoms, Wireless, IoT
Quectel Wireless Solutions has announced the Quectel BG95-S5 3GPP non-terrestrial network (NTN) satellite communication module.
Read more...SIMCom’s A7673x series Otto Wireless Solutions
Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat.1 bis module based on the ASR1606 chipset, that supports wireless communication modes of LTE-FDD, with a maximum downlink rate of 10 Mbps and a maximum uplink rate of 5 Mbps.
Read more...Long-range connectivity module Avnet Silica
Telecoms, Datacoms, Wireless, IoT
Digi XBee XR 868 RF Modules support the deployment of long-range connectivity applications, and support point-to-point and mesh networking protocols.
Read more...4G LTE-M/NB-IoT connectivity reference design iCorp Technologies
Telecoms, Datacoms, Wireless, IoT
Developed around the industry-leading Nordic nRF9160 module, the platform comes complete with a newly-developed LTE antenna, ATRIA, which is pre-certified to operate over the full LTE-M and NB-IoT bands.
Read more...Antennas to meet all connectivity requirements Electrocomp
Telecoms, Datacoms, Wireless, IoT
Kyocera AVX RF antennas meet today’s connectivity demands in the LTE, Wi-Fi, Bluetooth, GNSS, and ISM wireless bands, available in surface mount, patch or external configurations.
Read more...Introducing SIMCom’s new A7673X series Otto Wireless Solutions
Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat 1 bis module that supports LTE-FDD, with a maximum downlink rate of 10 Mbps and an uplink rate of 5 Mbps.
Read more...18 W monolithic microwave amplifier RFiber Solutions
Telecoms, Datacoms, Wireless, IoT
The CHA8612-QDB is a two stage, high-power amplifier operating between 7,9 and 11 GHz. The monolithic microwave amplifier can typically provide 18 W of saturated output power and 40% of power-added efficiency.