Telecoms, Datacoms, Wireless, IoT


Broadband RF ICs

26 May 2010 Telecoms, Datacoms, Wireless, IoT

Analog Devices has released two new RF ICs for broadband communications systems – the ADRF6655 active mixer and ADRF6510 dual programmable filter and VGA (variable gain amplifier).

Operating within the 100 to 2500 MHz frequency range, the ADRF6655 is a single-chip, broadband, active mixer with a fully integrated fractional-N phase locked loop (PLL) synthesiser, voltage controlled oscillator (VCO) and associated low dropout (LDO) regulator circuits. It provides high performance for both up- and down-conversion applications, and its PLL and VCO provide a fully integrated LO (local oscillator) circuit that can also be brought off-chip for external use. The mixer operates on a single +5 V supply and features input linearity IP3 of +29 dBm, input compression (P1dB) of +14 dBm, conversion gain of 6 dB, noise figure of 12 dB and LO phase noise of -111 dBc at 100 kHz offset.

The ADRF6510 is a dual-channel, fully differential baseband signal processing solution that integrates a matched pair of fully differential low-noise and low-distortion programmable filters and VGAs onto a single chip. The matched filter networks provide flexibility as the corner frequency is fully adjustable in 1 MHz steps, thereby enabling wideband and narrowband support within a single radio design.

The ADRF6510 VGA provides an adaptable multi-stage adjustable gain control range of 50 dB and a pre-amp prior to the filters provides a 6 dB step, while the VGAs that follow the filter networks provide gain range of -5 dB to +45 dB. This allows the user to select and optimise the gain range for high dynamic range radios and eases the drive requirements into the analog-to-digital converter. The chip provides low distortion > 60 dBc IMD3 suited for high-order QAM modulation, quadrature (I-Q) communications systems supporting high bandwidth signals up to 56 MHz.





Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Full sensor to cloud solution
CST Electronics Telecoms, Datacoms, Wireless, IoT
NeoCortec has demonstrated the seamless and rapid development of full sensor-to-cloud solutions using NeoMesh Click boards from MikroE and the IoTConnect cloud solution from Avnet.

Read more...
Long-range Wi-Fi HaLow module
TRX Electronics Telecoms, Datacoms, Wireless, IoT
One of Mouser’s newest products is the Morse Micro MM6108-MF08651-US Wi-Fi HaLow Module, which adheres to the IEEE 802.11ah standard.

Read more...
Quectel launches 3GPP NTN comms module
Quectel Wireless Solutions Telecoms, Datacoms, Wireless, IoT
Quectel Wireless Solutions has announced the Quectel BG95-S5 3GPP non-terrestrial network (NTN) satellite communication module.

Read more...
SIMCom’s A7673x series
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat.1 bis module based on the ASR1606 chipset, that supports wireless communication modes of LTE-FDD, with a maximum downlink rate of 10 Mbps and a maximum uplink rate of 5 Mbps.

Read more...
Accelerating the commercialisation of the 5G IoT markets
Altron Arrow Editor's Choice Telecoms, Datacoms, Wireless, IoT
Fibocom unveils Non-Terrestrial Networks (NTN) module MA510-GL, enabling satellite and cellular connectivity to IoT applications.

Read more...
Long-range connectivity module
Avnet Silica Telecoms, Datacoms, Wireless, IoT
Digi XBee XR 868 RF Modules support the deployment of long-range connectivity applications, and support point-to-point and mesh networking protocols.

Read more...
4G LTE-M/NB-IoT connectivity reference design
iCorp Technologies Telecoms, Datacoms, Wireless, IoT
Developed around the industry-leading Nordic nRF9160 module, the platform comes complete with a newly-developed LTE antenna, ATRIA, which is pre-certified to operate over the full LTE-M and NB-IoT bands.

Read more...
Antennas to meet all connectivity requirements
Electrocomp Telecoms, Datacoms, Wireless, IoT
Kyocera AVX RF antennas meet today’s connectivity demands in the LTE, Wi-Fi, Bluetooth, GNSS, and ISM wireless bands, available in surface mount, patch or external configurations.

Read more...
Introducing SIMCom’s new A7673X series
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat 1 bis module that supports LTE-FDD, with a maximum downlink rate of 10 Mbps and an uplink rate of 5 Mbps.

Read more...
18 W monolithic microwave amplifier
RFiber Solutions Telecoms, Datacoms, Wireless, IoT
The CHA8612-QDB is a two stage, high-power amplifier operating between 7,9 and 11 GHz. The monolithic microwave amplifier can typically provide 18 W of saturated output power and 40% of power-added efficiency.

Read more...