Power Electronics / Power Management


Battery backup system to maintain communications

18 May 2005 Power Electronics / Power Management

Aztec Electronics has developed the battery backup system for use with Motorola's micro-cell hardware on GSM networks. The purpose of the unit is to provide sufficient DC backup power in order to maintain network availability.

Aztec's Microcell Battery Backup unit contains two sealed lead-acid NorthStar NSB90FT batteries and is capable of supplying backup power to a single micro-cell transceiver for approximately 14 hours, or to two micro-cell transceivers for approximately 7 hours. The unit also contains an integrated switched-mode charger with LED indication and a 22 V low power drain voltage regulator as well as current and voltage meters.

The Microcell Battery Backup unit is wall mountable, lockable and protected against direct sunlight by its reflective outer heat shields.

For more information contact Dean Marcus, Aztec Electronics, +27 (0)11 828 0800, dmarcus@global.co.za





Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Local procurement should be top of mind in mine-owned solar power projects
Power Electronics / Power Management
Recent changes in government legislation have enabled businesses to develop up to 100 MW energy plants with very little red tape.

Read more...
The next big shift in SA's energy infrastructure
Power Electronics / Power Management
High-voltage (HV) LiFePO4 battery energy storage systems, commonly referred to as BESS, which drastically improve the power reliability prospects for businesses, have been around for some time, but expect to see a massive surge in 2024.

Read more...
Multi-channel electronic load series
Conical Technologies Power Electronics / Power Management
ITECH has recently announced the release of their upgraded IT8700P+ series multi-channel electronic loads. This new series supports master-slave parallel configuration between all the modules, allowing for different modules to be mixed and matched for synchronisation.

Read more...
Self-extinguishing batteries
Power Electronics / Power Management
The most commonly used electrolyte, which is highly combustible – a medium composed of a lithium salt and an organic solvent – is replaced with materials found in a commercial fire extinguisher.

Read more...
Input power bus conditioners
Accutronics Power Electronics / Power Management
The FLHG-60 and the FLHGI-60 are designed to be used as the front-end to the company’s MGDD N input series, to develop full power solutions.

Read more...
Isolated power module with high efficiency
RS South Africa Power Electronics / Power Management
The new MagI3C-FISM power module, with an integrated switching power stage, is 100% pin-to-pin compatible with the previous versions.

Read more...
Hi-Rel DC-DC converter
Accutronics Power Electronics / Power Management
The MGDD-06 series from GAÏA Converter is an ultra-wide input 6 W family of power converter modules, with a permanent input voltage range of 9 to 160 V DC.

Read more...
Energy measurement IC
CST Electronics Power Electronics / Power Management
The SY7T501 and SY7T502 are Silergy’s newest energy measurement ICs for cost-sensitive IoT applications such as smart-plugs, dimmers, power-strips, intelligent lighting, and other points of load.

Read more...
Reference design: USB-C PD and Qi charging
Power Electronics / Power Management
Infineon’s REF_TX15W_PD60W_N1 is the industry’s first turnkey solution to offer a PD and Qi multi-charger, allowing same-time charging via the USB-PC PD port and the Qi wireless power transmitter.

Read more...
SMD varistors with huge surge current capability
Electrocomp Power Electronics / Power Management
TDK Corporation has introduced two new varistor series in SMD design, the larger of the two capable of handling a surge current of 10 000 A.

Read more...