|
|
30 W DC-DC converters
30 April 2019, Power Electronics / Power Management
The 30 Watt JCM30, a new addition to XP Power’s range of compact low-power DC-DC converters, comes in a 2,54 x 2,54 cm encapsulated case for direct mounting onto a printed circuit board. The converter accommodates a wide 2:1 input voltage range, accepting either 9 – 18 V, 18 – 36 V or 36 - 75 V, covering the nominal inputs of +12, +24 or +48 V d.c.
Single-output models provide +3,3 V, +5 V, +12 V or +15 V d.c., while the dual-outputs offer ±5, ±12 or ±15 V d.c. All outputs are fully regulated to within ±0,5% over all input and load conditions for the single-output models and less than ±1,0% for the dual outputs.
The JCM30 can operate at full output power from -40°C to +100°C, and full load at 55°C, without derating. The converters feature an input-to-output and input/output-to-case isolation of 1600 V d.c. for up to 1 minute. These models feature a remote on/off control line that can be used to control the output rails or to sequence startup procedures. All units feature over-voltage and continuous short circuit protection, and come with a three-year warranty. |
|
|
|
| Share: |
 |
Via email client |
 |
 |
 |
 |
print |
|
|
|
|
|
Further reading:
- Rugged DC-DC converters
28 August 2019, Vepac Electronics, Power Electronics / Power Management
XP Power introduced two new series of wide input-range chassis- and DIN-rail mount DC-DC converters that offer simple and rapid installation into a wide variety of industrial and ITE applications. The ...
- Power controller for smart home appliances
28 August 2019, RF Design, Power Electronics / Power Management
Qorvo has introduced a new intelligent power control solution for reducing energy consumption, bulk, weight and noise in smart home appliances, AC-powered fans and compressors. This mixed-signal system-in-package ...
- 4-channel PC-based oscilloscope
28 August 2019, Vepac Electronics, Test & Measurement
The newly developed Model 1330 from Peaktech is a 4-channel PC oscilloscope with 100 MHz bandwidth and 1 GSps sample rate, which is suitable for mobile use on a laptop, and permanent installation in control ...
- UPS battery configuration made easy
28 August 2019, Forbatt SA, Power Electronics / Power Management
Determining the UPS (uninterruptible power supply) battery configuration using a formula can be quite complicated and, since many users are not very familiar with it, a more simplified method can be used ...
- Digital fibre-optic sensor
28 August 2019, Vepac Electronics, Opto-Electronics
The DFS digital fibre-optic sensor series from Tri-Tronics is designed to provide reliable detection using plastic fibre-optic light guides.
The slim-line housing with protective lid will fit in a variety ...
- All-in-one light pipe system
28 August 2019, Vepac Electronics, Opto-Electronics
Bivar’s Zero Light Bleed adaptor technology, with built-in surface-mount LED, channels light directly to the lens, eliminating disruptive light bleed.
The all-in-one adaptor system is built with optimum ...
- Bidirectional laboratory power supply
28 August 2019, Vepac Electronics, Power Electronics / Power Management
EA Elektro-Automatik’s new 30 kW EA-PSB 10000 is a bidirectional power supply with a working efficiency of up to 96%, both as a source and as a drain with energy feedback. The device can be switched from ...
- 3 Watt DC-DC converters
28 August 2019, Avnet South Africa, Power Electronics / Power Management
Aimtec has introduced three new series of switching regulators – the AMSRB1-78JZ, AMSRL1-78JZ and AMSRL-78JZ – all meeting the EN62368 standard and suitable for IoT (Internet of Things) applications.
The ...
- Isolated PFC module
28 August 2019, Conical Technologies, Power Electronics / Power Management
SynQor has added a new isolated PFC (power factor correction) module to its AeroQor range of products for the airborne electronics market. Featuring highly efficient active power factor correction, the ...
- DC-DC converter for DIN-rail mounting
28 August 2019, Vepac Electronics, Power Electronics / Power Management
MTM Power is offering the HSD series of primary switched DIN-rail modules with DC input voltage. The devices offer an input voltage range of 20 - 72 V d.c. and allow efficient solutions for different ...
- SMT test points and terminal pins
31 July 2019, Vepac Electronics, Interconnection
Vero Technologies, a leading manufacturer of test points and terminal pins in the PTH (plated through-hole) space, has a complementary range of SMT devices suitable for use with high-speed placement machines. ...
- DC UPS for DIN-rail mounting
31 July 2019, Vepac Electronics, Power Electronics / Power Management
The Effecta DCH series power supplies with UPS function are suitable for a variety of applications, and their robust IP 20 housing is applicable for all DIN-rail applications. With its power boost mode, ...
|
|
