Power Electronics / Power Management

High voltage blocking rectifiers

18 May 2005 Power Electronics / Power Management

One of the 'specialities' that Diotec manufactures are rectifiers that have blocking voltages higher than 1000 V.

Typical applications are 'clamper-damper' circuits as used in the horizontal deflection circuit of cathode ray tubes, electronic ballasts or any other application, where higher reverse voltages occur.

Devices with reverse voltage ratings up to 6000 V, and devices with forward currents up to 3 A, are available.


Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

STMicroelectronics’ new chip boosts energy efficiency
Future Electronics Power Electronics / Power Management
The new power-supply controller chip combines with ST’s MasterGaN technology in a laptop/smartphone charger design with energy recovery.

Powering your automotive electronics
Altron Arrow Power Electronics / Power Management
A look at the challenges of providing multiple supply rails to vehicle systems being powered from a single vehicle battery, with an available solution given.

Infineon releases new high-efficiency buck regulator module
EBV Electrolink Power Electronics / Power Management
This new buck regulator module has a 3 A single output with integrated inductor and offers high-efficiency load regulation in a compact package.

Thinner pattern coils set to revolutionise wireless charging
Electrocomp Power Electronics / Power Management
TDK developed the 0,76 mm thick charging coils using a unique pattern coil technology without employing conventional lithographic exposure and etching techniques.

Adjustable 1200 W power supply with near-to-zero output
Vepac Electronics Power Electronics / Power Management
Powerbox releases a 1200 W power supply, optimised for conduction cooling, which has adjustable near-to-zero output voltage and current.

10-channel, half-bridge motor driver with serial input control
NuVision Electronics Power Electronics / Power Management
The ten half-bridges can be controlled separately via a standard serial data interface, and each half-bridge has various diagnostic functions.

PowerDI8080 40 V MOSFET delivers industry-leading performance
Altron Arrow Power Electronics / Power Management
Diodes Incorporated has announced the introduction of the PowerDI80808-5, a power package that meets the needs of EV applications.

Solar-powered paver to harness clean energy
Power Electronics / Power Management
The PLATIO is a solar paver tile combined with a double green building material that not only generates clean energy but is also made from recycled plastic.

RF cavity filters for 5G
Electrocomp Telecoms, Datacoms, Wireless, IoT
Temwell has established a one-stop service for 5G RF cavity filters, featuring high specifications across a wide range of power requirements.

Multilayer ferrite beads
Electrocomp Passive Components
As direct replacements for the discontinued BMB series, TE Connectivity’s BMC multilayer ferrite beads cover a wide range of impedance characteristics.