Computer/Embedded Technology


Using CompactFlash in industrial PCs

19 October 2005 Computer/Embedded Technology

Most industrial PCs or single board computers (SBC) are fitted with CompactFlash sockets. This allows the system to boot and run from a CompactFlash instead of a hard disk drive. CompactFlashes are physically smaller and can handle shock and vibration much better than hard disk drives. They have simulated heads, sectors and cylinders just like normal hard disk drives, allowing the PC BIOS to treat them like a normal hard disk drive.

CompactFlash are also used in digital cameras. The high volume created by the demand from these and other consumer products have resulted in much lower pricing. Supplier competition has pushed pricing down further. All of this has been good for the industrial PC field. Lately however, the consumer market has required higher capacity and speed from the CompactFlash suppliers. This is needed to take more high resolution pictures at faster rates than before. Suppliers have responded by switching to a technology called MLC (multilevel control). This means each flash cell can have four different voltages, allowing them to store two digital bits in one flash cell. This doubles the capacity and increases the speed.

The data reliability however, is now lower. If one bit is read incorrectly, the shade of one of the colours of one pixel in a picture may be slightly wrong. Normally this is difficult to detect by an untrained eye. However, an incorrect bit in a PC's hard drive can easily cause the system to crash.

For this reason Centurion Micro Electronics (CME) supplies CompactFlash cards based on binary (not MLC) technology. Every cell only stores one digital bit using two voltage levels only. This type of CompactFlash is often referred to as industrial grade. They are also optionally-available in extended temperature ratings.

Sandisk used to supply industrial grade CompactFlash. Early this year, Sandisk stopped the production of these industrial grade items. Its Ultra Grade CompactFlash is however, also reasonably reliable and operates in most of the industrial PC applications. Simpletech has continued producing industrial grade CompactFlash based on binary technology. Both types are available from CME.



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

First NVMe SSD Built with 8th-gen BiCS FLASH
EBV Electrolink Computer/Embedded Technology
KIOXIA recently announced the development and prototype demonstration of its new KIOXIA CM9 Series PCIe 5.0 NVMe SSDs, which incorporates CMOS directly Bonded to Array technology.

Read more...
QuecPi smart development board
iCorp Technologies Computer/Embedded Technology
The QuecPi Alpha smart MOB development board is Quectel’s smart development board based on Qualcomm’s QCS6490 high-performance 64-bit octa-core processor.

Read more...
Eskom announces PV registration extension
Computer/Embedded Technology
The South African Photovoltaic Industry Association has welcomed Eskom’s decision to extend its zero-registration fee policy and free smart meter installation for residential Small-Scale Embedded Generation customers until March 2026.

Read more...
Unlock enhanced wireless performance
Computer/Embedded Technology
Duxbury Networking has introduced Cambium Networks’ Deep Virtual Circuit (Deep VC) technology, a free upgrade for the PMP 450 platform that will transform wireless broadband performance across the country.

Read more...
Computing in industrial environments
Vepac Electronics Computer/Embedded Technology
The Panasonic Toughbook CF-33/CF33 Tablet is a 12,0-inch fully rugged device with hot-swappable twin batteries and highly configurable capabilities.

Read more...
DDR5 DRAM series
Vepac Electronics Computer/Embedded Technology
Innodisk has announced its DDR5 6400 DRAM series featuring the industry’s largest 64GB single-module capacity.

Read more...
Generate waveforms at 10 GS/s
Vepac Electronics Computer/Embedded Technology
New flagship arbitrary waveform generator cards from Spectrum Instrumentation generate waveforms with 2,5 GHz bandwidth and 16-bit vertical resolution.

Read more...
Quad-port 10GBASE-T controller
Rugged Interconnect Technologies Computer/Embedded Technology
he SN4-DJEMBE, available from Rugged Interconnect, is a networking adaptor card for CompactPCI Serial systems, equipped with four individual controllers for 10GBASE-T.

Read more...
HPE policy management platform
Computer/Embedded Technology
Duxbury Networking has announced the availability of the HPE Aruba ClearPass policy management platform, that enables business and personal devices to connect to an organisational level, in compliance with corporate security policies.

Read more...
IoT gateways
Brandwagon Distribution Computer/Embedded Technology
IoT Gateways are hardware and software devices that are responsible for collecting data from connected devices, managing communication between devices and the cloud, and processing and analysing the data before sending it to the cloud for further analysis.

Read more...