Analogue, Mixed Signal, LSI


Auto-zero sensor amplifier

4 February 2009 Analogue, Mixed Signal, LSI

Texas Instruments has introduced a single-supply, auto-zero bridge sensor amplifier. Featuring programmable gain and offset, the PGA308 amplifies the sensor signal and provides digital calibration for zero (offset) and span (gain). A one-wire, UART-compatible digital serial interface performs the calibration. At the heart of the device is a precision, low-drift and low-noise front-end programmable gain amplifier (PGA). Digitally programmable coarse offset, fine offset and selected gain (coarse and fine) may be controlled in realtime or permanently programmed into the PGA308. The device can store seven banks of one-time programmable (OTP) memory of gain and offset calibration parameters. A separate power-on reset OTP bank can be programmed up to four times. A fault monitor detects overload, burnout and system faults, while the over-/under-scale limits offer additional system-level diagnostics.



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Compact 6 A automotive buck converter
Altron Arrow Power Electronics / Power Management
Delivering up to 6 A of continuous output current, the DCP0606Y from STMicroelectronics enables efficient regulation of low-voltage rails commonly used in modern vehicle electronics and industrial systems.

Read more...
Next-gen modules for rugged edge AI systems
Altron Arrow Computer/Embedded Technology
Designed for real-world edge deployments where systems do not sit still, SolidRun’s P100 COMx6 series targets mobile platforms as well as harsh, mission-critical environments.

Read more...
NXP has expanded its MCX A Series
Altron Arrow AI & ML
NXP has significantly expanded its MCX A Series of Arm Cortex-M33 microcontrollers, doubling the portfolio with six new families aimed at industrial and IoT edge applications.

Read more...
Surviving the extremes: Understanding shock and vibration in MEMS sensors
Altron Arrow Editor's Choice Test & Measurement
By considering factors such as mechanical headroom, damping, and system-level robustness, designers can ensure that the chosen sensor not only survives, but performs reliably over time.

Read more...
Exploring Bluetooth Channel Sounding
Altron Arrow Telecoms, Datacoms, Wireless, IoT
NXP has enabled BCS on the MCX W72 multi-protocol wireless MCU, which supports Bluetooth Low Energy 6.0, Thread, Zigbee, and Matter.

Read more...
Dual-band Wi-Fi 6 companion module
Altron Arrow Telecoms, Datacoms, Wireless, IoT
The SimpleLink Wi-Fi CC33xx family of devices from Texas Instruments are dual-band Wi-Fi 6 companion modules enabling engineers to connect more applications with confidence.

Read more...
Power module enhances AI data centre power density
Altron Arrow Power Electronics / Power Management
Microchip’s MCPF1525 power module with PMBus delivers 25 A DC-DC power and is stackable up to 200 A.

Read more...
High-performance linear regulator
Altron Arrow Power Electronics / Power Management
The TI TPS7A57-Q1 is an automotive-grade, high-performance low-dropout linear regulator, engineered for precision power delivery in noise-sensitive systems.

Read more...
Quad RF ADC/DAC for wideband transceiver design
Altron Arrow DSP, Micros & Memory
The AD9084 from Analog Devices integrates a quad 16-bit RF digital-to-analogue converter with a maximum sampling rate of 28 GSPS and a quad 12-bit RF analogue-to-digital converter.

Read more...
Collaboration to explore 10BASE-T1S SPE
Altron Arrow Telecoms, Datacoms, Wireless, IoT
The collaboration between Microchip and Hyundai aims to evaluate and promote the adoption of advanced in-vehicle network technologies leveraging each company’s strengths.

Read more...









While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved