Opto-Electronics


LED lighting controller

22 June 2011 Opto-Electronics

International Rectifier introduced the IRS2548D switched mode power supply control IC for high-power LED illumination including street lighting, stadium lighting and theatrical lighting. The chip, which combines power factor correction and half-bridge driver, offers greater than 88% efficiency for a 40 V/1,3 A HBLED load to deliver an efficient solution at power levels above 60 W. The device achieves PWM dimming down to less than 2% light output and offers protection features that include programmable PFC and half-bridge over-current protection, latch immunity and ESD protection. It also includes variable frequency oscillator, fixed internal 1,6 μs deadtime, internal bootstrap MOSFET, internal 15,6 V zener clamp diode on VCC and 250 μA startup.

Future Electronics, +27 (0)21 421 8292, [email protected], www.futureelectronics.com



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

PhotoMOS relays
Future Electronics Opto-Electronics
The AQY221R2SX and AQY221R2S PhotoMOS from Panasonic Industry ensures excellent characteristics and high-speed switching performance.

Read more...
Mouser now shipping onsemi’s image sensors
TRX Electronics Opto-Electronics
The AR0145CS is a 1/4,3-inch CMOS digital image sensor with a 1280 (H) x 800 (V) active-pixel array that can capture both continuous video and single frames.

Read more...
Adaptive optics’ power solution
Altron Arrow Opto-Electronics
Vicor power-dense adaptive optical modules enable colossal telescopes to look into the past for deep space discoveries.

Read more...
Ultra-high speed photo detection
Opto-Electronics
TDK Corporation has announced a photo-spintronic conversion element combining optical, electronic, and magnetic elements that can respond at an ultra-high speed of 20 picoseconds.

Read more...
High-speed lasers
RFiber Solutions Opto-Electronics
Macom are a high-volume manufacturer of lasers, deploying more than 100 million devices with a reliability of less than 50 FIT and greater than 100 years of wear-out lifetime

Read more...
High-performance optical interconnect
Opto-Electronics
STMicroelectronics has unveiled its next generation of proprietary technologies for higher-performing optical interconnect in datacentres and AI clusters.

Read more...
MEMS air quality sensor
Future Electronics Test & Measurement
Bosch Sensortec’s BME690 is the latest-generation gas sensor that combines advanced monitoring capabilities with innovative artificial intelligence functionality.

Read more...
Halo mid-board optical transceiver
Spectrum Concepts Opto-Electronics
The Samtec Halo mid-board transceiver has been designed for next-generation embedded applications that require 56 and 112 Gbps PAM4 performance in low profile and ruggedised form factors.

Read more...
New generation of Ethernet media converters
IOT Electronics Opto-Electronics
Phoenix Contact is introducing three new families of media converters to the market, each designed for specific industrial environments and challenges.

Read more...
PIN photodiode with integrated lens
RFiber Solutions Opto-Electronics
The MARP-BP112 from Macom is a backside-illuminated PIN photodiode, usable from 1200 nm to 1650 nm, that is optimised for use in 112 GBaud PAM4 applications.

Read more...