Terminal blocks
6 July 2011
Interconnection
A new disconnect and base terminal block has joined WAGO’s TOPJOB S 2002 series, offering three jumper slots instead of the usual two. This allows the terminal block to be commoned on both sides of the knife disconnect. This new version can also be used as a base terminal block for a fuse holder or component plug. Furthermore, the additional jumper slot may be used as a test point and can accommodate TOPJOB S connectors. It distributes both the signals for the fuse holder and the disconnect signals on the input and output sides.
The terminal block is available in the following versions: with hinged or pluggable fuse holder, as ground (earth) conductor (yellow-green) and through terminal blocks or blade-style fuse terminal block with blown fuse indication. All versions are rated at 16 A and are suitable for EN 500 V and UL 300 V applications. The nominal cross section is 2,5 mm², allowing the terminal block to accommodate 0,25 to 4 mm² conductors. Marking options include centre and side marking locations.
For more information contact Shorrock Automation, +27 (0)12 345 4449, [email protected], www.shorrock.co.za
Further reading:
Designing with PCIe
Spectrum Concepts
Editor's Choice Interconnection
PCI Express has become the backbone of modern high-performance systems with each new generation promising higher bandwidth, but that performance comes with a cost.
Read more...
Connectivity solutions for hydrogen technologies
Hiconnex
Interconnection
As the production distribution and utilisation of hydrogen continue to scale, connectivity becomes a key enabler for efficient energy transmission, data communication, and system control.
Read more...
Robust single-pole power connectivity
Hiconnex
Interconnection
Designed for cable-to-cable and cable-to-equipment use, Radiall’s single-pole power connector support current ratings from 250 A to 750 A and operating voltages up to 1000 V AC or DC.
Read more...
M12 push-pull connectors
IOT Electronics
Interconnection
Phoenix Contact’s M12 push-pull connectors with internal locking set a new benchmark for fast, secure, and space-saving connectivity in industrial automation.
Read more...
Versatile outdoor waterproof connectors
Vepac Electronics
Interconnection
The LP-20 outdoor waterproof connector series offers a versatile range of rugged, circular connectors with 2, 3, 4, 5, 7, 8, 9, 12 and 14-pin configurations.
Read more...
Comprehensive range of data connectors
IOT Electronics
Interconnection
Phoenix Contact’s comprehensive range of data connectors provides reliable connection solutions for modern networked applications across industrial, infrastructure, and commercial environments.
Read more...
Compact inline connector for aerospace
Hiconnex
Interconnection
Radiall’s Small Inline Connector series is a fully qualified wire-to-wire solution designed to simplify harness creation, installation, and modification in aerospace applications.
Read more...
Compact hybrid power storage connector
IOT Electronics
Interconnection
Phoenix Contact has introduced a new hybrid connector for electrical energy storage systems, designed to combine power, signal, and data transmission in a single, compact interface.
Read more...
MIL-spec connector series
Future Electronics
Interconnection
The MIL-HD2 connector series from Amphenol is the company’s next-generation, SOSA-aligned solution engineered to meet the most demanding requirements of modern military embedded systems.
Read more...
DC connectors approved for 2000 V
IOT Electronics
Interconnection
Phoneix Contact’s Sunclix DC connectors are now approved for system voltages of up to 2000 V in accordance with TÜV Rheinland’s new test specification, opening the door to higher-voltage PV designs and reduced system costs.
Read more...
printer friendly version