Opto-Electronics


Constant-current LED driver

2 May 2012 Opto-Electronics

Texas Instruments added a new off-line primary side sensing controller to its portfolio of non-dimming LED drivers. The TPS92310 AC/DC constant current driver with power factor correction (PFC) is suitable for high-power LED retrofit bulbs, including A19, PAR30/38 and GU10.

The device’s AC input voltage supports common line voltages of 100 V, 120 V, 230 V, 240 V and 277 V. True primary side sensing and regulation provides accurate LED current regulation, eliminating optocoupler, secondary error amplifier and associated passive components.

Two operating modes are available: adaptive constant on-time (COT) mode provides inherent power factor correction with no external components, while peak current control provides low LED current ripple to minimise stroboscopic effects.

Critical conduction mode (CCM) with zero current detection (ZCD) provides valley switching for improved power conversion efficiency and low EMI. Cycle-by-cycle current limit, over/under-voltage protection and thermal shutdown protect the LED driver and user against faults and abnormal operating conditions.



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Microchip expands maXTouch M1 touchscreen controller
Altron Arrow DSP, Micros & Memory
Microchip Technology has again expanded its maXTouch M1 family of touchscreen controllers, now covering free-form widescreen format displays up to 42 inches down to small compact screens in the 2 to 5 inch range.

Read more...
ToF sensor with 6 m range
Altron Arrow Test & Measurement
Specifically designed for long-range, multitarget measurements, the VL53L4CX from ST Microelectronics provides very accurate distance measurements up to 6 m with excellent results over short distances.

Read more...
Microchip expands its Arm Cortex-M0+ portfolio
Altron Arrow DSP, Micros & Memory
PIC32CM PL10 MCUs feature a rich set of Core Independent Peripherals, 5 V operation, touch capabilities, integrated toolsets, and safety compliance.

Read more...
High-voltage X-Ray generators for advanced imaging
Vepac Electronics Opto-Electronics
X-ray has developed a high-performance range of HV generators designed for accuracy, long-term durability, and seamless integration into OEM environments.

Read more...
More room to scale
Altron Arrow Power Electronics / Power Management
With the latest STM32H5 lines from STMicroelectronics, you can now scale within the same platform, from a compact 1 Mbyte device to higher-memory MCUs for graphics-rich and feature-heavy designs.

Read more...
Multi-constellation GNSS module in a legacy-compatible footprint
Altron Arrow Telecoms, Datacoms, Wireless, IoT
Telit Cinterion has announced the SE869eK2L, a single-frequency L1 GNSS module designed to help device manufacturers upgrade legacy positioning designs with improved performance and cost efficiency, while preserving design continuity.

Read more...
Compact SSI family for industrial automation
Altron Arrow Passive Components
Infineon Technologies has introduced the ISSI20BxxF Solid State Isolator (SSI) family, bringing solid-state isolation technology into high-volume applications traditionally served by photovoltaic isolators (PVIs), photovoltaic relays (PVRs), and electromechanical relays (EMRs).

Read more...
Rev 2.0 PolarFire FPGA ethernet sensor bridge
Altron Arrow Computer/Embedded Technology
Smaller, multi-camera platform enables scalable Ethernet architectures for NVIDIA Edge AI systems, while lowering power, cost and integration complexity.

Read more...
Universal IR receiver module
Altron Arrow Telecoms, Datacoms, Wireless, IoT
Vishay Intertechnology has introduced a new series of infrared (IR) receiver modules for IR remote control applications, which feature a wide modulation frequency acceptance from 30 kHz to 68 kHz.

Read more...
Low profile SMD antenna
Altron Arrow Telecoms, Datacoms, Wireless, IoT
The Havok PCS.06.A antenna, from Taoglas, is a low profile SMD LTE/cellular 4G/3G/2G embedded antenna designed for direct SMD mount on a device PCB.

Read more...









While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved