RS232 to RS422/485 interface converter with software
15 August 2001
Computer/Embedded Technology
Sealevel Systems' RS232 to RS422/485 interface converter allows a standard RS232 port to communicate with an individual RS422 device or with multiple devices within a RS485 network. The IC485 supports RS422 full duplex mode as well as RS485 full or half duplex master and slave modes. This gives the user flexibility in configuring the device to meet specific application needs. Onboard LEDs are included to indicate that the device is properly powered and also illuminate when the device is transmitting and receiving to assist in verifying acceptable communications. A six-position screw terminal block on the board provides connection to external devices. Provisions for strain relief are made within the case by a cable clamp/screw combination.
The included Sealevel Software solves a common problem with most RS232 to RS422/485 interface converters. Sealevel enhanced the Windows COM: drivers to provide RTS software control for the IC485 when in RS485 RTS mode. Windows abstracts the user from the hardware, therefore implementing features not supported by the standard Windows COM:driver requires custom software development.
Further reading:
Rugged combo antennas cut multi-network installations down to one
iCorp Technologies
Computer/Embedded Technology
Quectel Wireless Solutions has expanded its antenna portfolio with four rugged multi-network combo antennas.
Read more...
Intelligent video processing
Rugged Interconnect Technologies
Computer/Embedded Technology
The CHARM150AGX is based on a NVIDIA AGX Orin embedded processor, which incorporates a multicore ARM processor and powerful AI/ML accelerator.
Read more...
Quectel’s single-board computers put industrial edge computing on one PCB
iCorp Technologies
Computer/Embedded Technology
Quectel Pi series of single-board computers (SBCs), designed for a broad range of industrial applications, include three compact development platforms – the Quectel Pi M1, L1, and H1 boards.
Read more...
Nordic expands nRF Cloud with firmware vulnerability scanning
RF Design
Computer/Embedded Technology
nRF Cloud identifies vulnerabilities in firmware and shows exactly which deployed devices are affected, empowering device manufacturers to address EU Cyber Resilience Act requirements.
Read more...
Arrival of the Epic-PTH9
Vepac Electronics
Computer/Embedded Technology
AAEON introduces the EPIC-PTH9, a compact 4-inch industrial single-board computer powered by Intel Core Ultra Series 3 (formerly Panther Lake) processors.
Read more...
EPS-9600 Managed Layer 3 Ethernet Switch with next-generation Time- Sensitive Networking
Electronic Products Design
Computer/Embedded Technology
Diamond Systems has introduced EPS-9610 (part of the EPS-9600 family), a rugged, ultra-compact embedded Ethernet switch which integrates military-grade ruggedness with next-generation Time-Sensitive Networking (TSN) capabilities.
Read more...
An industry-first Android 16 smart module solution
RF Design
Computer/Embedded Technology Telecoms, Datacoms, Wireless, IoT
The MeiG Smart SLM580 4G Smart Module features native support for Android 16 and covers core frequency bands in major countries and regions worldwide.
Read more...
Accelerate STM32-based IoT development with SPI EEPROM board
Altron Arrow
Computer/Embedded Technology
ST Microelectronics’ ready-to-use STM32 expansion board helps design more efficient battery-friendly IoT devices based on ultra low power 32-Mbit Page.
Read more...
Unleash the next generation of Intel Core power
Vepac Electronics
Computer/Embedded Technology
The EPIC-BTS9 from AAEON, is tailor-made to bring unprecedented performance to smart manufacturing and industrial robotics.
Read more...
QMC series I/O modules for VITA 93 small form factor mezzanine
Rugged Interconnect Technologies
Computer/Embedded Technology
The new line of VITA 93 QMC mezzanine modules, from Acromag, are engineered to meet increasing demands for smaller form factors and more performance.
Read more...
printer friendly version