Power Electronics / Power Management


Automotive low-side power switches

27 August 2014 Power Electronics / Power Management

STMicroelectronics offers a wide range of automotive-grade 3- and 5-pin low-side switches based on the company’s VIPower (vertical intelligent power) technology. This proprietary technology allows integration of complete digital and analog control and protection circuits driving a vertical power MOSFET, all on the same chip.

With its OmniFET III series based on VIPower M0-5 technology, ST offers a power limitation overload protection scheme that limits the current below the higher threshold during inrush, while reducing the threshold to a lower value during thermal cycling, so limiting thermal stresses and increasing the global lifetime of the device.

Designed to work from -40°C to +150°C, the product portfolio includes single and dual drivers with digital status and on-resistance values ranging from 10 m to 300 m. Furthermore, with their open load and short circuits to VCC detection, active even with the device in the off-state, these low-side drivers are a safe way to drive and protect a lamp or any other load in a car.

For more information contact Robin Scholes, Arrow Altech Distribution, +27 (0)11 923 9600, [email protected], www.arrow.altech.co.za



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Rugged railway-grade DC-DC power modules
iCorp Technologies Power Electronics / Power Management
iCorp Technologies has introduced the AIPUPOWER ZCD100 and ZCD150 Series, a family of rugged DC-DC converters designed to meet the demanding electrical and environmental requirements of railway and transportation systems.

Read more...
NXP has expanded its MCX A Series
Altron Arrow AI & ML
NXP has significantly expanded its MCX A Series of Arm Cortex-M33 microcontrollers, doubling the portfolio with six new families aimed at industrial and IoT edge applications.

Read more...
Surviving the extremes: Understanding shock and vibration in MEMS sensors
Altron Arrow Editor's Choice Test & Measurement
By considering factors such as mechanical headroom, damping, and system-level robustness, designers can ensure that the chosen sensor not only survives, but performs reliably over time.

Read more...
Four-quadrant regenerative grid simulator
Conical Technologies Power Electronics / Power Management
The IT7900EP series high-performance regenerative grid simulator from ITECH is a full four-quadrant AC grid simulator capable of both sourcing and sinking power.

Read more...
90 W PSU with 150% boost capability
Brabek Power Electronics / Power Management
RECOM’s cost effective REFIN2U-S90/CL DIN rail AC/DC boasts a 90 W rating with a boost capability of 150% for 4,5 seconds to allow for surge loads.

Read more...
Exploring Bluetooth Channel Sounding
Altron Arrow Telecoms, Datacoms, Wireless, IoT
NXP has enabled BCS on the MCX W72 multi-protocol wireless MCU, which supports Bluetooth Low Energy 6.0, Thread, Zigbee, and Matter.

Read more...
Standalone USB PD controller
Future Electronics Power Electronics / Power Management
The STUSB4531 from STMicroelectronics is a standalone USB Power Delivery sink controller designed to streamline the implementation of USB-C power negotiation in sink devices without requiring a full software stack on a host microcontroller.

Read more...
Dual-band Wi-Fi 6 companion module
Altron Arrow Telecoms, Datacoms, Wireless, IoT
The SimpleLink Wi-Fi CC33xx family of devices from Texas Instruments are dual-band Wi-Fi 6 companion modules enabling engineers to connect more applications with confidence.

Read more...
Power module enhances AI data centre power density
Altron Arrow Power Electronics / Power Management
Microchip’s MCPF1525 power module with PMBus delivers 25 A DC-DC power and is stackable up to 200 A.

Read more...
MIL-Spec DC-DC power converters
Vepac Electronics Power Electronics / Power Management
PowerGood has introduced a range of 15 W to 600 W military DC-DC power converters engineered for mission critical defence applications.

Read more...









While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved