Computer/Embedded Technology


Compact PCI platform with 14-slot CT backplane

29 January 2003 Computer/Embedded Technology

The MIC-3031/14 from Advantech is a compact PCI enclosure. The 6U sized 14-slot backplane provides one slot for a CPU board and 13 peripheral slots with H.110 CT bus connection on all P4 connectors for TDM signals on computer telephony applications.

The MIC-3031/14 supports IEEE 1101.11 rear I/O transition cards. Users can route I/O signals to the rear transition cards for simplified system cabling. Front boards are free to load and remove without any wiring. Its 2U high integrated fan tray has three parallel 86-CFM high speed hot swap fans which provide forced cool air into the system. The fans are individually hot swappable allowing users to replace any of the fans without interrupting the operation of the system.

Three AC input 280 W hot-swap load-sharing power supply units operate in an N+1 configuration with a redundant 560 W power. The drive bay can accommodate up to three 5,25" drives and two 3,5" drives. An internal alarm module provides system fault detection and alarm notification. The alarm module provides one serial port and relay outputs on the rear side of the MIC-3031/14. The serial port can be configured as RS232, RS485, or linked to a modem for communicating with the remote host for realtime monitoring and reporting.



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

New generation of SBCs
Computer/Embedded Technology
HardKernel’s new generation of ODROID H4-series SBCs are more powerful; offering higher performance and richer interfaces than previous generations.

Read more...
Smallest 13th gen Intel SBC
Vepac Electronics Computer/Embedded Technology
At just 86 x 55 mm, the de next-RAP8 continues AAEON’s run of producing record-breaking single-board computers with embedded Intel technology.

Read more...
Versatile PoE extender
Vepac Electronics Computer/Embedded Technology
The GP-101ET PoE+ Extender is a 1-port Gigabit PoE extender with plug and play installation requiring neither configuration nor extra electrical power.

Read more...
First NVMe SSD Built with 8th-gen BiCS FLASH
EBV Electrolink Computer/Embedded Technology
KIOXIA recently announced the development and prototype demonstration of its new KIOXIA CM9 Series PCIe 5.0 NVMe SSDs, which incorporates CMOS directly Bonded to Array technology.

Read more...
QuecPi smart development board
iCorp Technologies Computer/Embedded Technology
The QuecPi Alpha smart MOB development board is Quectel’s smart development board based on Qualcomm’s QCS6490 high-performance 64-bit octa-core processor.

Read more...
Eskom announces PV registration extension
Computer/Embedded Technology
The South African Photovoltaic Industry Association has welcomed Eskom’s decision to extend its zero-registration fee policy and free smart meter installation for residential Small-Scale Embedded Generation customers until March 2026.

Read more...
Unlock enhanced wireless performance
Computer/Embedded Technology
Duxbury Networking has introduced Cambium Networks’ Deep Virtual Circuit (Deep VC) technology, a free upgrade for the PMP 450 platform that will transform wireless broadband performance across the country.

Read more...
Computing in industrial environments
Vepac Electronics Computer/Embedded Technology
The Panasonic Toughbook CF-33/CF33 Tablet is a 12,0-inch fully rugged device with hot-swappable twin batteries and highly configurable capabilities.

Read more...
DDR5 DRAM series
Vepac Electronics Computer/Embedded Technology
Innodisk has announced its DDR5 6400 DRAM series featuring the industry’s largest 64GB single-module capacity.

Read more...
Generate waveforms at 10 GS/s
Vepac Electronics Computer/Embedded Technology
New flagship arbitrary waveform generator cards from Spectrum Instrumentation generate waveforms with 2,5 GHz bandwidth and 16-bit vertical resolution.

Read more...









While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved