Opto-Electronics


Improved IR receiver modules

29 March 2023 Opto-Electronics

Newly enhanced infrared modules from Vishay Intertechnology have been upgraded with a new IC ,and achieve higher performance with drastically reduced current consumption. The modules operate over a wide voltage supply range and offer improved robustness against ESD and direct sunlight.

These latest-generation miniaturised IR receivers combine the photo detector and preamplifier in one package, which provides improvements in sensitivity when in the presence of CFLs. The devices contain a pin diode and a preamplifier assembled on a lead frame, and the package contains a built-in IR filter. The demodulated signal can be directly coupled to a microprocessor for decoding.

The devices are designed to receive short burst codes of six or more carrier cycles per burst. The third digit designates the AGC level (AGC1, AGC3 or AGC5), and the last two digits designate the band-pass frequency. The higher the AGC, the better the noise is suppressed, but the lower the code compatibility.


Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

PhotoMOS relays
Future Electronics Opto-Electronics
The AQY221R2SX and AQY221R2S PhotoMOS from Panasonic Industry ensures excellent characteristics and high-speed switching performance.

Read more...
Mouser now shipping onsemi’s image sensors
TRX Electronics Opto-Electronics
The AR0145CS is a 1/4,3-inch CMOS digital image sensor with a 1280 (H) x 800 (V) active-pixel array that can capture both continuous video and single frames.

Read more...
Adaptive optics’ power solution
Altron Arrow Opto-Electronics
Vicor power-dense adaptive optical modules enable colossal telescopes to look into the past for deep space discoveries.

Read more...
Ultra-high speed photo detection
Opto-Electronics
TDK Corporation has announced a photo-spintronic conversion element combining optical, electronic, and magnetic elements that can respond at an ultra-high speed of 20 picoseconds.

Read more...
High-speed lasers
RFiber Solutions Opto-Electronics
Macom are a high-volume manufacturer of lasers, deploying more than 100 million devices with a reliability of less than 50 FIT and greater than 100 years of wear-out lifetime

Read more...
High-performance optical interconnect
Opto-Electronics
STMicroelectronics has unveiled its next generation of proprietary technologies for higher-performing optical interconnect in datacentres and AI clusters.

Read more...
First NVMe SSD Built with 8th-gen BiCS FLASH
EBV Electrolink Computer/Embedded Technology
KIOXIA recently announced the development and prototype demonstration of its new KIOXIA CM9 Series PCIe 5.0 NVMe SSDs, which incorporates CMOS directly Bonded to Array technology.

Read more...
IMU with dual-sensing capability
EBV Electrolink Analogue, Mixed Signal, LSI
ST’s 6-axis inertial measurement unit integrates a dual accelerometer up to 320g and embedded AI for activity tracking and high-impact sensing.

Read more...
Halo mid-board optical transceiver
Spectrum Concepts Opto-Electronics
The Samtec Halo mid-board transceiver has been designed for next-generation embedded applications that require 56 and 112 Gbps PAM4 performance in low profile and ruggedised form factors.

Read more...
New generation of Ethernet media converters
IOT Electronics Opto-Electronics
Phoenix Contact is introducing three new families of media converters to the market, each designed for specific industrial environments and challenges.

Read more...