Maxim's MAX6846-MAX6849 are adjustable single-/dual-level battery monitors combined with independent microprocessor supervisory reset circuits. These devices monitor single lithium-ion (Li+) cell or multicell NiMH/NiCd/alkaline applications. The MAX6846-MAX6849 consume only 2,5 µA of supply current, making them ideal for portable handheld applications.
In typical systems, the low-battery output (LBO) asserts and disconnects the load from the system when the battery voltage falls below its threshold. The battery voltage often recovers and reconnects the load, only to cause the LBO to reassert and cause chatter. These devices eliminate chattering by providing internal hysteresis. The MAX6846-MAX6849 have user-adjustable thresholds for setting the voltage-trip thresholds. All devices have a low-battery output that can be used to shut the system off when the battery is dead. The MAX6848/9 have an additional low-battery output that can provide an early low-battery warning, allowing the system to enter a low-power mode or to back up critical data into memory. All low-battery outputs have active-low, open-drain configurations.
The MAX6846-MAX6849 also feature an independent microprocessor supervisory circuit that monitors system voltages from 1,8 to 3,3 V. Seven factory-trimmed reset thresholds are available with two reset timeout options of 150 ms or 1200 ms (min). The MAX6846/8 have an active-low, open-drain reset, and the MAX6847/9 have an active-low, push-pull reset output. The MAX6846/7 also have a one-shot manual-reset input.
The devices are available in 8-pin SOT23 packages and are fully specified from -40°C to +85°C.
12 kW hybrid inverter
Power Electronics / Power Management
Sungrow recently unveiled its next-generation residential energy storage solution, expanding its power range from 5 kW to 12 kW with the introduction of the new MG12RL hybrid inverter.
Read more...40 W and 75 W railway DC/DC converter Brabek
Power Electronics / Power Management
RECOM has announced two new cost-efficient DC/DC converters for the rail market with an ultra-wide 11:1 input range to cover all nominal input voltages from 24 to 110 V DC.
Read more...Power modules for solid-state transformers RS South Africa
Power Electronics / Power Management
Microchip’s new 3,3 kV silicon carbide modules deliver the required thermal performance and efficiency for SSTs to increase power available for token generation.
Read more...Solving South African power problems with locally built intelligence
Editor's Choice Power Electronics / Power Management
Smart metering infrastructure in South Africa remains patchy. The rollout has been slow, coverage is inconsistent, and for the most part, granular per-unit measurement simply does not exist.
Read more...Wide range power module
Power Electronics / Power Management
The latest DC-DC modules from Würth Elektronik are characterised by high resilience to voltage transients on the 24 V bus and an extremely wide input-voltage range from 3,5 V to 38 V.
Read more...Powering smart sensor networks CST Electronics
Telecoms, Datacoms, Wireless, IoT
NeoCortec’s NeoMesh wireless mesh networking protocol and software stack is ideally suited for powering smart sensor networks where each device is required to send and receive small packets of data infrequently, but with high reliability.
Read more...Selecting primary batteries for maximum service life Uniross Batteries
Power Electronics / Power Management
Primary batteries play an important role in IoT applications. Designed for longevity, they have a high-energy capacity and are often used in standalone applications where charging is impractical or impossible.
Read more...4 kW e-mobility DC-DC converter Brabek
Power Electronics / Power Management
The RECOM RMOD4000 series of compact, plug-and-play DC-DC converters is a cost-effective solution to provide isolated 14 V, 28 V, or 56 V DC network rails from a high input voltage between 180 and 950 V DC.
Read more...Aluminium case upgrade boosts performance Vepac Electronics
Power Electronics / Power Management
The SQBF Quarter Brick 300 W DC to DC Converter is now available in a newly upgraded metal case designed to deliver improved durability and superior electrical performance across demanding applications.
Read more...Extending the range of power converters RS South Africa
Power Electronics / Power Management
Power Integrations recently announced a breakthrough in flyback topology extending the power range of flyback converters to 440 W - well beyond the limits that traditionally required more complex resonant and LLC topologies.
While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.
printer friendly version