Maxim's new EEPROM-programmable, hex/quad power-supply sequencers/supervisors with an integrated 10-bit ADC are system-management devices that combine voltage monitoring, supervisory functions, margining control, and sequencing control. The MAX6870/1 devices are programmed through an I²C interface that selects monitored voltage thresholds, sequence and reset-timing specifications, and sets output configurations. Internal configuration EEPROM is used to store and update changes as necessary.
The MAX6870 features six voltage-detector inputs and eight programmable outputs, while the MAX6871 features four voltage-detector inputs and five programmable outputs. All voltage detectors offer dual voltage thresholds in 10 mV increments for undervoltage, overvoltage, or dual undervoltage detection. These detectors can be configured to assert any of the outputs when any voltage is out of regulation.
The programmable outputs can be used to sequence supplies or provide system resets and interrupts with active-high or active-low logic. These outputs can be configured with open-drain, push-pull, and a charge-pump option (for driving external n-channel MOSFETs). There are eight available timeout periods ranging from 25 μs to 1600 ms. A margining enable input is available to set the outputs into a default (or disable) state.
An internal 8-channel, 10-bit ADC reads back the all the monitored voltages and two external inputs into its ADC registers. The ADC can be used to monitor voltage during margining or when trimming a power supply. Other features include four general-purpose inputs, two watchdog timers, and a manual reset input. The devices are available in a 7 mm x 7 mm QFN package and specified for -40 to +85°C.
Quality batteries are critical for IIoT Uniross Batteries
Power Electronics / Power Management
Batteries intended for use in industrial operations must indeed offer complete reliability under extreme environmental conditions, resistance to vibration and harsh environments.
Read more...12 kW hybrid inverter
Power Electronics / Power Management
Sungrow recently unveiled its next-generation residential energy storage solution, expanding its power range from 5 kW to 12 kW with the introduction of the new MG12RL hybrid inverter.
Read more...40 W and 75 W railway DC/DC converter Brabek
Power Electronics / Power Management
RECOM has announced two new cost-efficient DC/DC converters for the rail market with an ultra-wide 11:1 input range to cover all nominal input voltages from 24 to 110 V DC.
Read more...Power modules for solid-state transformers RS South Africa
Power Electronics / Power Management
Microchip’s new 3,3 kV silicon carbide modules deliver the required thermal performance and efficiency for SSTs to increase power available for token generation.
Read more...Solving South African power problems with locally built intelligence
Editor's Choice Power Electronics / Power Management
Smart metering infrastructure in South Africa remains patchy. The rollout has been slow, coverage is inconsistent, and for the most part, granular per-unit measurement simply does not exist.
Read more...Wide range power module
Power Electronics / Power Management
The latest DC-DC modules from Würth Elektronik are characterised by high resilience to voltage transients on the 24 V bus and an extremely wide input-voltage range from 3,5 V to 38 V.
Read more...DC-link capacitors with ultra-low inductance Electrocomp
Passive Components
TDK Corporation recently released its new series of MKP DC high-frequency film capacitors, a high-performance DC link capacitor platform for next-generation SiC-based power electronics.
Read more...Powering smart sensor networks CST Electronics
Telecoms, Datacoms, Wireless, IoT
NeoCortec’s NeoMesh wireless mesh networking protocol and software stack is ideally suited for powering smart sensor networks where each device is required to send and receive small packets of data infrequently, but with high reliability.
Read more...Selecting primary batteries for maximum service life Uniross Batteries
Power Electronics / Power Management
Primary batteries play an important role in IoT applications. Designed for longevity, they have a high-energy capacity and are often used in standalone applications where charging is impractical or impossible.
Read more...4 kW e-mobility DC-DC converter Brabek
Power Electronics / Power Management
The RECOM RMOD4000 series of compact, plug-and-play DC-DC converters is a cost-effective solution to provide isolated 14 V, 28 V, or 56 V DC network rails from a high input voltage between 180 and 950 V DC.
While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.
printer friendly version