|
|
Design kit brings Ethernet to serial devices
14 May 2008, Telecoms, Datacoms, Wireless, IoT
The Luminary Micro Stellaris Serial-to-Ethernet Reference Design Kit (RDK-S2E) offers a complete, open-tool, and ready-to-implement solution designed to add Web connectivity to any serial device.
Included in the kit is the tiny-footprint Stellaris Serial-to-Ethernet Module (MDL-S2E). The most common application for the MDL-S2E is for augmenting legacy products that only contain a serial port for a configuration or control interface. In addition, newer computers, especially laptop computers, do not necessarily have serial ports, and a serial connection is limited by a typical cable length of 10 metres. Simply installing a Serial-to-Ethernet Module into the legacy serial device provides many benefits including no major board redesign or software changes, easy sharing on a network other than Ethernet, tiny form-factor for unobtrusive implementation, and the 10-metre maximum cable length for serial connections is no longer a limitation.
The MDL-S2E features a highly integrated ARM Cortex-M3 microcontroller with 50 MHz of performance and ample single-cycle, on-chip Flash and SRAM memory for efficient network traffic handling. For maximum space savings, the microcontroller is offered in a small BGA package and integrates the 10/100 Ethernet MAC and PHY on-chip. |
|
|
|
| Share: |
 |
Via email client |
 |
 |
 |
 |
print |
|
|
|
|
|
Further reading:
- Flexible wall-mount whip antenna
26 June 2019, RF Design, Telecoms, Datacoms, Wireless, IoT
The Cyclops WM.95 from Taoglas is a high-efficiency (over 50%) 915 MHz flexible whip antenna with a screw-mounted wall-mount L bracket. The radiation pattern is omnidirectional in the azimuth, allowing ...
- Bluetooth LE pass-through module
26 June 2019, Icorp Technologies, Telecoms, Datacoms, Wireless, IoT
The HM-BT4501 from HopeRF is a wireless data pass-through module based on a CMT4501 low-power Bluetooth 5.0 chip. By connecting with a microcontroller, it can be used to realise a connection and data ...
- Positioning module for autonomous driving
26 June 2019, RF Design, Telecoms, Datacoms, Wireless, IoT
The ZED-F9K from u-blox is a high-precision multiband GNSS (global navigation satellite system) module with built-in inertial sensors. The module combines the latest generation of GNSS receiver technology, ...
- Passive filter design for an ultra-low noise buck regulator
26 June 2019, NuVision Electronics, Power Electronics / Power Management
Switched-mode power supplies (SMPS) have the advantage of high efficiency compared to traditional low-dropout (LDO) regulators. Due to its switching nature, an SMPS emits noise at its switching frequency ...
- Automotive smart hub ICs
26 June 2019, Avnet South Africa, Telecoms, Datacoms, Wireless, IoT
Microchip Technology has added new single-port USB smart hub ICs to its family of USB automotive products. The USB4912 and the USB4712 can be used to add a single port under the radio, in the centre console ...
- Wideband amplifier for instrumentation
26 June 2019, RFiber Solutions, Telecoms, Datacoms, Wireless, IoT
MACOM Technology Solutions announced a new wideband distributed amplifier with the introduction of the MAAM-011275-DIE. Offered as a bare die, this amplifier is well suited for use in test and measurement ...
- Positioning and cellular antenna
26 June 2019, RF Design, Telecoms, Datacoms, Wireless, IoT
The Tycho MA310 antenna is a combination, small form factor GPS/GLONASS and penta-band cellular (GSM/GPRS/CDMA/ PCS/DCS/ WCDMA/UMTS) antenna to simplify AVL or fleet management antenna systems worldwide.
Made ...
- RF power doubler
26 June 2019, RF Design, Telecoms, Datacoms, Wireless, IoT
The QPA3357 from Qorvo is a power doubler that operates from 47 to 1218 MHz. It provides an output power of 57 dBm, a gain of 28 dB, and has a noise figure of 4,5 dB. This power doubler is matched to ...
- Ka-band power amplifier
26 June 2019, RFiber Solutions, Telecoms, Datacoms, Wireless, IoT
MACOM Technology Solutions’ new MAAP-011250 is a balanced 4 W power amplifier (PA) operating from 27,5 – 30 GHz, making it well suited for SATCOM and VSAT applications.
With the addition of this new ...
- Flexible wideband antenna
26 June 2019, RF Design, Telecoms, Datacoms, Wireless, IoT
The Taoglas FXUB64.18.0150C flexible wideband antenna has been designed to cover all working frequencies in the 600-3000 MHz spectrum, covering all cellular, 2,4 GHz Wi-Fi, ISM, NB-IoT, CAT-M1 and A-GPS ...
- High-frequency power dividers
26 June 2019, RF Design, Telecoms, Datacoms, Wireless, IoT
Pasternack has launched a new series of high-frequency power dividers targeted at 5G cellular communication, automotive radar and satellite communication applications.
The lineup consists of 17 new ...
- Cellular module for LPWA applications
26 June 2019, RF Design, Telecoms, Datacoms, Wireless, IoT
u-blox has announced the SARA R5 series of LTE M and NB-IoT modules for low power wide area (LPWA) IoT applications. The module, built on the UBX R5 cellular chipset and the M8 GNSS receiver chip, is ...
|
|
