LED driver reduces EMI

26 October 2011 Opto-Electronics

Switching at a frequency of up to 1 MHz and ensuring closely controlled rise and fall times, the AL8807 buck LED driver from Diodes Incorporated has been purpose designed to reduce EMI issues in the lower-cost MR16 LED lamp market. To achieve required higher output powers, the IC can operate at input voltages between 6 V to 30 V and provide up to 8 series-connected LEDs with a constant 1 A current.

The driver’s current accuracy of ±5% means it will meet the requirements of most general low-voltage lighting applications and lead to an improvement in inter-lamp luminance matching in 3 W LED lighting systems. The driver is up to 96% efficient and its output current is simple to set using a single external resistor.

Dimming control is via the application of either a DC voltage or PWM signal on the driver’s control input, which also protects against any over-driving of the LED current. The AL8807’s 1000:1 PWM dimming ratio and DC dimming range from 16% to 100% provide users with flexible and wide-ranging lamp brightness control.

Further reading:

PhotoMOS relays
Future Electronics Opto-Electronics
The AQY221R2SX and AQY221R2S PhotoMOS from Panasonic Industry ensures excellent characteristics and high-speed switching performance.

Read more...

---

Mouser now shipping onsemi’s image sensors
TRX Electronics Opto-Electronics
The AR0145CS is a 1/4,3-inch CMOS digital image sensor with a 1280 (H) x 800 (V) active-pixel array that can capture both continuous video and single frames.

Read more...

---

Adaptive optics’ power solution
Altron Arrow Opto-Electronics
Vicor power-dense adaptive optical modules enable colossal telescopes to look into the past for deep space discoveries.

Read more...

---

Ultra-high speed photo detection
Opto-Electronics
TDK Corporation has announced a photo-spintronic conversion element combining optical, electronic, and magnetic elements that can respond at an ultra-high speed of 20 picoseconds.

Read more...

---

High-speed lasers
RFiber Solutions Opto-Electronics
Macom are a high-volume manufacturer of lasers, deploying more than 100 million devices with a reliability of less than 50 FIT and greater than 100 years of wear-out lifetime

Read more...

---

High-performance optical interconnect
Opto-Electronics
STMicroelectronics has unveiled its next generation of proprietary technologies for higher-performing optical interconnect in datacentres and AI clusters.

Read more...

---

Halo mid-board optical transceiver
Spectrum Concepts Opto-Electronics
The Samtec Halo mid-board transceiver has been designed for next-generation embedded applications that require 56 and 112 Gbps PAM4 performance in low profile and ruggedised form factors.

Read more...

---

New generation of Ethernet media converters
IOT Electronics Opto-Electronics
Phoenix Contact is introducing three new families of media converters to the market, each designed for specific industrial environments and challenges.

Read more...

---

PIN photodiode with integrated lens
RFiber Solutions Opto-Electronics
The MARP-BP112 from Macom is a backside-illuminated PIN photodiode, usable from 1200 nm to 1650 nm, that is optimised for use in 112 GBaud PAM4 applications.

Read more...

---

RGBIR sensor with I2C interface
Electrocomp Opto-Electronics
Available in a miniature opaque 2,67 x 2,45 mm package, Vishay’s VEML6046X00 includes high-sensitivity photodiodes, a low noise amplifier, and a 16-bit analogue to digital converter.

Read more...

---