Electrocomp

Tel: +27 11 458 9000
Email: [email protected]
www: www.electrocomp.co.za
more information about Electrocomp

USB 2.0 host controller
23 January 2013, Electrocomp, Telecoms, Datacoms, Wireless, IoT

FTDI has strengthened its portfolio of USB semiconductor solutions with the release of the FT313H host controller IC. It supports USB 2.0 hi-speed (480 Mbps) as well as full-speed (12 Mbps) and low-speed ...
read more


Transient current suppressors
23 January 2013, Electrocomp, Circuit & System Protection

Bourns announced the release of new TCS (transient current suppressor) high-speed protectors, designed to provide enhanced protection for very high data rate differential lines. The TCS-DL series helps ...
read more


Resettable fuses
28 November 2012, Electrocomp, Circuit & System Protection

Bourns announced the introduction of its new MF-RM series of Multifuse polymer PTC resettable fuses. This radial through-hole series is Bourns’ first family of PTCs that can operate on an AC mains circuit ...
read more


Thyristor surge protectors
14 November 2012, Electrocomp, Circuit & System Protection

Bourns announced the release of the TISP4SxxxyyBJR-S series of single bidirectional thyristor surge protectors, designed to limit over-voltages on telephone lines. A single device provides 2-point protection ...
read more


USB 2.0 controllers
31 October 2012, Electrocomp, Telecoms, Datacoms, Wireless, IoT

Future Technology Devices International (FTDI) has revealed the FT12 series of high-performance USB controller ICs. Operating at 12 Mbps and designed to the USB 2.0 specification, the new controllers ...
read more


Surface temperature sensors
31 October 2012, Electrocomp, Test & Measurement

TDK has expanded its NTCGP series of NTC temperature sensors with types featuring lug terminals for the precise measurement of surface temperatures from -40°C to +150°C. With their metal lug terminals, ...
read more


Common-mode filter
31 October 2012, Electrocomp, Circuit & System Protection

TDK has developed a common-mode filter which measures in at only 0,45 x 0,30 x 0,23 mm and is 75% smaller than current 0806 filters (IEC). With a high cutoff frequency of 7,0 GHz the TCM0403S-350-2P ...
read more


Protection diodes for Gigabit Ethernet
3 October 2012, EBV Electrolink, Electrocomp, Circuit & System Protection

Infineon Technologies released a new TVS (transient voltage suppression) diode to protect Gigabit Ethernet interfaces from potential damage due to voltage surge or electrostatic discharge (ESD) events. ...
read more


Surge arrester stack for telecoms equipment
3 October 2012, Electrocomp, Circuit & System Protection

TDK has introduced a new EPCOS gas-filled surge arrester consisting of a stack of five individual arresters, developed specifically to protect the power supplies of telecommunications equipment. Its rated ...
read more


USB host IC for Android platforms
19 September 2012, Electrocomp, Telecoms, Datacoms, Wireless, IoT

FTDI is supporting the Android Open Accessories initiative with the introduction of its FT311D, a USB Full-Speed (12 Mbps) host IC specifically targeted at providing Android platforms, such as tablet ...
read more


Power factor controller
22 August 2012, Electrocomp, Power Electronics / Power Management

TDK has extended its range of EPCOS power factor controllers. The new BR7000-I controller is designed specifically for single-phase networks and combines all the performance features and functions of ...
read more


MLCCs withstand high voltages
22 August 2012, Electrocomp, Passive Components

TDK has developed a multilayer ceramic chip capacitor that – in addition to its rated DC voltage of 630 V – can withstand a rated AC voltage of 500 VRMS for 60 seconds and 600 VRMS for 3 seconds. Thanks ...
read more





<< First   < Previous   Page 38 of 125   Next >   Last >>







While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved