RF Design

Tel: +27 21 555 8400
Email: [email protected]
www: www.rfdesign.co.za
more information about RF Design

Communication controller for smart homes
10 October 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

Qorvo introduced a new system in package (SiP) that enables dynamic, simultaneous support for Zigbee 3.0, Green Power, Thread and Bluetooth Low Energy (BLE). It integrates Qorvo power amplifier technology ...
read more


NB-IoT antennas
10 October 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

Taoglas has launched three NB-IoT antennas, including a compact ceramic NB-IoT antenna and an ultra-thin, flexible multiband antenna that supports all LTE bands. The low-profile, highly efficient NCP.5820 ...
read more


Zigbee certified SoC
10 October 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

Nordic Semiconductor’s nRF52840 multiprotocol system-on-chip (SoC) can now be used to build and ship commercial Zigbee designs. This means Nordic customers can now build and ship commercial Zigbee products ...
read more


High-isolation MMIC mixer
10 October 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

The MM1-0832L/H double-balanced GaAs MMIC mixer from Marki Microwave is a suitable solution for X through Ka bands, with full coverage for traditional satcom uplink and downlink applications. RF/LO frequency ...
read more


Programmable Ethernet-serial controllers
10 October 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

Available from Tibbo is a trio of compact and affordable serial controllers which are programmable in Tibbo BASIC and Tibbo C. Features include Wi-Fi, PoE (Power over Ethernet), display, RS-232, RS-485, ...
read more


How high is a coaxial cable’s maximum frequency?
10 October 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

Coaxial cable is the most commonly used transmission line for RF and microwave applications, because it provides reliable transmission with the benefits of wide bandwidth, low loss and high isolation. ...
read more


LoRa transceiver module
12 September 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

The S76S LoRa wireless communication module, designed and manufactured by AcSiP Technology, is a system-in-package (SiP) housed in a 13 x 11 x 1,1 mm LGA form factor. Powered by an integrated Semtech ...
read more


Wirewound ferrite beads
12 September 2018, RF Design, Circuit & System Protection

Coilcraft offers a broad range of wirewound ferrite beads in standard package sizes from 0201 (0603) to 1812 (4532). Elevated attenuation and frequency performance enable smaller solution sizes compared ...
read more


High-power PIN diode RF switches
12 September 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

Pasternack has unveiled a new line of SPDT high-power PIN diode RF switches that offer desirable performance for transmit and receive signal routing applications. Typical applications can involve use ...
read more


Introduction to coaxial cable losses
15 August 2018, RF Design, Interconnection

Coaxial cable transfers radio frequency power from one point to another and, in the ideal world, the same amount of power would transfer along the cable to the remote end of the coax cable. However, real ...
read more


Tough GNSS antenna
15 August 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

The AQHA.11 GNSS quadrifilar helix antenna is a high-performance GNSS (global navigation satellite system) L1 antenna for demanding GPS / GLONASS / BeiDou / Galileo applications. Its wide bandwidth allows ...
read more


USB dongle for wireless development
15 August 2018, RF Design, Telecoms, Datacoms, Wireless, IoT

Nordic Semiconductor has launched a low-cost USB dongle for its nRF Connect for Desktop PC tool that allows developers to immediately connect their PCs to a wireless device with only one end of the wireless ...
read more





<< First   < Previous   Page 40 of 131   Next >   Last >>







While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved