Telecoms, Datacoms, Wireless, IoT


RFID transponder coils for harsh environments

25 August 2021 Telecoms, Datacoms, Wireless, IoT

Coilcraft’s 5315TC Series of RFID transponder coils was developed for tyre pressure monitoring systems and designed to handle harsh mechanical environments.

The 5315TC is Coilcraft’s most rugged and lowest-cost antenna coil designed for RFID applications at 125 kHz. The wrap-around terminals have large mounting surfaces to ensure excellent board adhesion and the coil is wound on a plastic base, providing extended durability and allowing this part to withstand harsh mechanical shock. Their robust construction and 125°C rating make these parts suitable for use in the most severe environments.

They were developed for automotive applications, including but not limited to tyre pressure monitoring systems. In addition to the standard models, Coilcraft can design transponder coils to operate at other frequencies. The Coilcraft Designer’s Kit C369 contains four samples each of the standard parts.

For more information contact Andrew Hutton, RF Design, +27 21 555 8400, andrew@rfdesign.co.za, www.rfdesign.co.za


Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Compact Bluetooth LE and Wi-Fi module
RF Design Telecoms, Datacoms, Wireless, IoT
u-blox announces compact Bluetooth LE and Wi-Fi module which combines Wi-Fi 4 and Bluetooth 5.0 with a powerful open CPU.

Read more...
Using Wlink cellular routers for telematics
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
In addition to Wi-Fi, cellular networks could be used to facilitate communication between remote vehicles and monitoring centres.

Read more...
Tibbo powers cloud-enabled traceability systems
RF Design Telecoms, Datacoms, Wireless, IoT
The wireless nature of the WS1102 allows units (and attached barcode scanners) to be moved freely between workstations.

Read more...
0,9-18 GHz miniature receiver module
RFiber Solutions Telecoms, Datacoms, Wireless, IoT
Atlanta Micro’s AM9018 is designed for low-SWaP applications and can be mounted to a host circuit board for use in multi-channel receiver applications.

Read more...
2-way power divider
RF Design Telecoms, Datacoms, Wireless, IoT
The power divider is suitable for use in test and measurement, satcom, commercial, military and wireless communication applications.

Read more...
5 GHz Wi-Fi front-end module
RF Design Telecoms, Datacoms, Wireless, IoT
A key feature of the integrated logarithmic power detector is to enable power control across the entire power spectrum.

Read more...
NFC/RFID demonstration kit
Altron Arrow Telecoms, Datacoms, Wireless, IoT
The boards are powered through their USB connectors and are supported by downloadable schematics, BOM, Gerber files, drivers and firmware sources.

Read more...
5G modules for industrial and commercial IoT
iCorp Technologies Telecoms, Datacoms, Wireless, IoT
Quectel’s RG50xQ series is capable of delivering a downlink rate of 2,5 Gbps and an uplink rate of 900 Mbps.

Read more...
Automatic gain-controlled amplifier
RF Design Telecoms, Datacoms, Wireless, IoT
The device is designed for rugged military environments and can be customised with an optional time delay adjustment and phase modulation compression.

Read more...
2 GHz to 18 GHz bandpass filter bank
RFiber Solutions Telecoms, Datacoms, Wireless, IoT
Atlanta Micro’s new AM3215 is a 2 GHz to 18 GHz bandpass filter bank with low loss and high rejection, ideally suited for low-SWaP applications.

Read more...