Computer/Embedded Technology


PCI-bus multifunction DAS card

13 August 2003 Computer/Embedded Technology

A multifunction DAS card for the PCI bus is available from ProMicro. The PCI-1710/1710HG provides 12-bit A/D conversion, D/A conversion, digital input, digital output and counter/timer functions.

The card features an automatic channel/gain scanning circuit. The circuit, rather than the software, controls multiplexer switching during sampling. Its onboard SRAM stores different gain values and configurations for each channel, providing multichannel, high-speed sampling up to 100 kHz with different gains for each channel.

An on-board FIFO buffer can store up to 4 K A/D samples, and the cards generate an interrupt when the FIFO is half full, providing continuous high speed data transfer. The programmable counter generates a pacer trigger for the A/D conversion. The counter chip is an 82C54 or equivalent, which includes three 16-bit counters on a 10 MHz clock. One counter is used as an event counter and the other two are cascaded together to make a 32-bit timer for a pacer trigger.

Specially designed shielded cable is available for the PCI-1710/1710HG cards to reduce noise in the analog signal lines, to minimise cross-talk and to reduce EMI/EMC interference.



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Rugged, I/O-rich NVIDIA Jetson solutions
Electronic Products Design Computer/Embedded Technology
Developed for the NVIDIA Jetson AGX Orin, the Osbourne carrier and development kit is a compact and rugged platform designed to support a wide range of embedded AI and edge computing applications.

Read more...
New generation of SBCs
Computer/Embedded Technology
HardKernel’s new generation of ODROID H4-series SBCs are more powerful; offering higher performance and richer interfaces than previous generations.

Read more...
Smallest 13th gen Intel SBC
Vepac Electronics Computer/Embedded Technology
At just 86 x 55 mm, the de next-RAP8 continues AAEON’s run of producing record-breaking single-board computers with embedded Intel technology.

Read more...
Versatile PoE extender
Vepac Electronics Computer/Embedded Technology
The GP-101ET PoE+ Extender is a 1-port Gigabit PoE extender with plug and play installation requiring neither configuration nor extra electrical power.

Read more...
First NVMe SSD Built with 8th-gen BiCS FLASH
EBV Electrolink Computer/Embedded Technology
KIOXIA recently announced the development and prototype demonstration of its new KIOXIA CM9 Series PCIe 5.0 NVMe SSDs, which incorporates CMOS directly Bonded to Array technology.

Read more...
QuecPi smart development board
iCorp Technologies Computer/Embedded Technology
The QuecPi Alpha smart MOB development board is Quectel’s smart development board based on Qualcomm’s QCS6490 high-performance 64-bit octa-core processor.

Read more...
Eskom announces PV registration extension
Computer/Embedded Technology
The South African Photovoltaic Industry Association has welcomed Eskom’s decision to extend its zero-registration fee policy and free smart meter installation for residential Small-Scale Embedded Generation customers until March 2026.

Read more...
Unlock enhanced wireless performance
Computer/Embedded Technology
Duxbury Networking has introduced Cambium Networks’ Deep Virtual Circuit (Deep VC) technology, a free upgrade for the PMP 450 platform that will transform wireless broadband performance across the country.

Read more...
Computing in industrial environments
Vepac Electronics Computer/Embedded Technology
The Panasonic Toughbook CF-33/CF33 Tablet is a 12,0-inch fully rugged device with hot-swappable twin batteries and highly configurable capabilities.

Read more...
DDR5 DRAM series
Vepac Electronics Computer/Embedded Technology
Innodisk has announced its DDR5 6400 DRAM series featuring the industry’s largest 64GB single-module capacity.

Read more...









While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved