Telecoms, Datacoms, Wireless, IoT


13,56 MHz RFID transceiver

25 November 2009 Telecoms, Datacoms, Wireless, IoT

The MLX90121 from Melexis is an ISO compliant 13,56 MHz RFID transceiver IC. Its main features include user-selectable modulation depth in write mode, while single subcarrier, FSK and PSK modulations are recognised in the read mode. The receiver is based on a diode envelope detector, followed by an IF filter and amplifier. A logarithmic amplifier is used for single subcarrier detection, ensuring fast and clean data recovery. The limiting output of the log amp is used for FSK and PSK recovery.

The transmitter uses a built-in open drain output transistor, which can provide up to 250 mW of RF power to a 50 Ω load with a 5 V power supply using the recommended matching network. This is suitable for most short- to mid-range applications. A simplified antenna and matching network can be used, at the expense of a reduced reading range, for example in handheld reader applications.

The chip is configured with a serial interface. A synchronisation signal is available when the majority voting is used. The part contains FSK (423/484 kHz) and PSK (847 kHz) decoders and a programmable encoder to facilitate data handling with a low-cost microcontroller. The encoder can be programmed with six different patterns. The chip can also be used as an analog frontend, in direct mode.

For more information contact Larry Gordon, CST Electronics, +27 (0)11 608 0070, [email protected], www.cstelectronics.co.za



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Full sensor to cloud solution
CST Electronics Telecoms, Datacoms, Wireless, IoT
NeoCortec has demonstrated the seamless and rapid development of full sensor-to-cloud solutions using NeoMesh Click boards from MikroE and the IoTConnect cloud solution from Avnet.

Read more...
Long-range Wi-Fi HaLow module
TRX Electronics Telecoms, Datacoms, Wireless, IoT
One of Mouser’s newest products is the Morse Micro MM6108-MF08651-US Wi-Fi HaLow Module, which adheres to the IEEE 802.11ah standard.

Read more...
Quectel launches 3GPP NTN comms module
Quectel Wireless Solutions Telecoms, Datacoms, Wireless, IoT
Quectel Wireless Solutions has announced the Quectel BG95-S5 3GPP non-terrestrial network (NTN) satellite communication module.

Read more...
SIMCom’s A7673x series
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat.1 bis module based on the ASR1606 chipset, that supports wireless communication modes of LTE-FDD, with a maximum downlink rate of 10 Mbps and a maximum uplink rate of 5 Mbps.

Read more...
Accelerating the commercialisation of the 5G IoT markets
Altron Arrow Editor's Choice Telecoms, Datacoms, Wireless, IoT
Fibocom unveils Non-Terrestrial Networks (NTN) module MA510-GL, enabling satellite and cellular connectivity to IoT applications.

Read more...
Banana Pi with NPU
CST Electronics AI & ML
The latest Banana Pi SBC, the BPI-M7, is powered by Rockchip’s latest flagship RK3588 octa-core 64-bit processor, with a maximum frequency of 2,4 GHz.

Read more...
Long-range connectivity module
Avnet Silica Telecoms, Datacoms, Wireless, IoT
Digi XBee XR 868 RF Modules support the deployment of long-range connectivity applications, and support point-to-point and mesh networking protocols.

Read more...
4G LTE-M/NB-IoT connectivity reference design
iCorp Technologies Telecoms, Datacoms, Wireless, IoT
Developed around the industry-leading Nordic nRF9160 module, the platform comes complete with a newly-developed LTE antenna, ATRIA, which is pre-certified to operate over the full LTE-M and NB-IoT bands.

Read more...
Antennas to meet all connectivity requirements
Electrocomp Telecoms, Datacoms, Wireless, IoT
Kyocera AVX RF antennas meet today’s connectivity demands in the LTE, Wi-Fi, Bluetooth, GNSS, and ISM wireless bands, available in surface mount, patch or external configurations.

Read more...
Introducing SIMCom’s new A7673X series
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat 1 bis module that supports LTE-FDD, with a maximum downlink rate of 10 Mbps and an uplink rate of 5 Mbps.

Read more...