Analogue, Mixed Signal, LSI


Energy measurement processors

20 February 2013 Analogue, Mixed Signal, LSI

Maxim is sampling new 78M6610+PSU/78M6610+LMU single-phase energy measurement processors. These processors are an energy measurement subsystem in a single chip, designed to provide simple utility-grade sensing and diagnostics for existing designs without the traditional cost of a utility meter system-on-chip. Both devices contain unique firmware to meet end-application requirements. The 78M6610+PSU is specifically designed for real-time monitoring of data centres, servers, and telecom and data equipment, while the 78M6610+LMU is a more general-purpose solution for applications such as white-good appliances, smart plugs, EV chargers and solar inverters.



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Full sensor to cloud solution
CST Electronics Telecoms, Datacoms, Wireless, IoT
NeoCortec has demonstrated the seamless and rapid development of full sensor-to-cloud solutions using NeoMesh Click boards from MikroE and the IoTConnect cloud solution from Avnet.

Read more...
Banana Pi with NPU
CST Electronics AI & ML
The latest Banana Pi SBC, the BPI-M7, is powered by Rockchip’s latest flagship RK3588 octa-core 64-bit processor, with a maximum frequency of 2,4 GHz.

Read more...
Hardened-grade network switches
CST Electronics Computer/Embedded Technology
Lantronix’s hardened switches provide Layer 2 or Layer 3 networking, and are available as Power-over-Ethernet (PoE) or Power-over-Ethernet Plus (PoE+).

Read more...
Energy measurement IC
CST Electronics Power Electronics / Power Management
The SY7T501 and SY7T502 are Silergy’s newest energy measurement ICs for cost-sensitive IoT applications such as smart-plugs, dimmers, power-strips, intelligent lighting, and other points of load.

Read more...
Easy wireless mesh networking
CST Electronics Telecoms, Datacoms, Wireless, IoT
NeoCortec has announced three new NeoMesh Click boards that are ideal for wireless mesh networking, eliminating the need for engineers to create any development PCB hardware themselves.

Read more...
LoRa transceiver module
CST Electronics Telecoms, Datacoms, Wireless, IoT
The RYLR896 transceiver module from REYAX features the LoRa long range modem that provides ultra-long range spread spectrum communication.

Read more...
High-performance antenna solution
CST Electronics Telecoms, Datacoms, Wireless, IoT
The Spitfire Series of antennas delivers exceptional performance with its dipole design, ground plane independence, and easy wall-mount versatility for both indoor and outdoor environments.

Read more...
SMD antenna for GNSS L1 band
CST Electronics Telecoms, Datacoms, Wireless, IoT
Antenova has recently launched the Admotus SMD antenna, a ceramic antenna suitable for all GNSS positioning applications in the L1 band covering 1559 to 1609 MHz.

Read more...
High-speed PIN diode
Altron Arrow Analogue, Mixed Signal, LSI
Vishay’s new high-speed Silicon PIN diode is able to detect both visible and near infra-red radiation over a wide spectrum range from 350 to 1100 nm.

Read more...
Analogue front end for sensor measurements
Electrocomp Analogue, Mixed Signal, LSI
The NJU9103 AFE from Nisshinbo is a tiny analogue front end, with a 16-bit resolution ADC and up to 512 x signal amplification from the programmable gain amplifier.

Read more...