Telecoms, Datacoms, Wireless, IoT


Sub-GHz wireless sensor board

10 August 2016 Telecoms, Datacoms, Wireless, IoT

Available from STMicroelectronics is the STEVAL-IDI005V1, a wireless sensor board powered by a CR2032 coin-cell battery. The board is designed to provide several example sub-GHz, Smart Home and Smart Things applications, such as heat allocator, smart remote control and wireless sensor node with 868 MHz sub-GHz connectivity.

Based on the SP1ML 868 MHz sub-GHz module, the board includes firmware to communicate with the STEVAL-SP1ML868 USB dongle for the SPIRIT1 module. With these, a point-to-point network can be created with a master STEVAL-SP1ML868 (connected to a PC via HyperTerminal or similar) and STEVAL-IDI005V1 slaves nodes.

Using HyperTerminal on the USB port connected to the STEVAL-SP1ML868 USB dongle, AT commands can be sent to monitor the humidity, temperature, motion XYZ, LED and button status information on the STEVAL-IDI005V1 node.

Alternatively, demo firmware for point-to-point (P2P) communication between two STEVALIDI005V1 boards is available on request. In this case, a node 1 board communicates with another node 2 board, which lights an LED on the remote board when the button on the first board is pressed.

For more information contact Robin Scholes, Arrow Altech Distribution, +27 (0)11 923 9600, rscholes@arrow.altech.co.za, www.arrow.altech.co.za



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Microchip expands maXTouch M1 touchscreen controller
Altron Arrow DSP, Micros & Memory
Microchip Technology has again expanded its maXTouch M1 family of touchscreen controllers, now covering free-form widescreen format displays up to 42 inches down to small compact screens in the 2 to 5 inch range.

Read more...
Macom targets broadband radar with time delay MMIC
RFiber Solutions Telecoms, Datacoms, Wireless, IoT
Macom’s MADU FR1012 is a GaAs MMIC 1-bit true time delay device covering 4 GHz to 12 GHz, designed for broadband microwave systems where beam accuracy and signal integrity are critical.

Read more...
ToF sensor with 6 m range
Altron Arrow Test & Measurement
Specifically designed for long-range, multitarget measurements, the VL53L4CX from ST Microelectronics provides very accurate distance measurements up to 6 m with excellent results over short distances.

Read more...
Compact analogue phase shifter
RF Design Telecoms, Datacoms, Wireless, IoT
The Mini-Circuits JSPHS-150+ is a compact analogue voltage-controlled phase shifter designed for narrowband RF applications between 100 and 150 MHz.

Read more...
Microchip expands its Arm Cortex-M0+ portfolio
Altron Arrow DSP, Micros & Memory
PIC32CM PL10 MCUs feature a rich set of Core Independent Peripherals, 5 V operation, touch capabilities, integrated toolsets, and safety compliance.

Read more...
More room to scale
Altron Arrow Power Electronics / Power Management
With the latest STM32H5 lines from STMicroelectronics, you can now scale within the same platform, from a compact 1 Mbyte device to higher-memory MCUs for graphics-rich and feature-heavy designs.

Read more...
Wireless connectivity expanded
iCorp Technologies Telecoms, Datacoms, Wireless, IoT
Espressif Systems has introduced two new members of its ESP32 wireless SoC family: the ESP32-E22, the company’s first Wi-Fi 6E connectivity chip, and the ESP32-H21, an ultra-low-power Bluetooth LE microcontroller aimed at coin-cell and battery-powered devices.

Read more...
Integrated X-band radar front-end module
RF Design Telecoms, Datacoms, Wireless, IoT
Qorvo has introduced an X-band radar front-end solution that enables defence system designers to achieve higher performance without increasing size, weight or prime power.

Read more...
Introducing Aurata
CST Electronics Telecoms, Datacoms, Wireless, IoT
Antenova has launched Aurata SR4L112: a compact, high efficiency embedded 4G/LTE antenna engineered for long, narrow PCB designs.

Read more...
Multi-constellation GNSS module in a legacy-compatible footprint
Altron Arrow Telecoms, Datacoms, Wireless, IoT
Telit Cinterion has announced the SE869eK2L, a single-frequency L1 GNSS module designed to help device manufacturers upgrade legacy positioning designs with improved performance and cost efficiency, while preserving design continuity.

Read more...









While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved