Telecoms, Datacoms, Wireless, IoT


RF synthesiser with integrated VCOs operates to 5 GHz

3 October 2007 Telecoms, Datacoms, Wireless, IoT

STMicroelectronics has unveiled a new RF synthesiser with integrated voltage-controlled oscillators (VCOs) with very broad frequency coverage.

The STW81103 is a single-chip device that operates up to 5 GHz, meeting the increasing demand of equipment manufacturers for space and cost-efficient solutions in radio applications with frequencies in the microwave range. Among the applications in which these devices may find application are wireless network infrastructures, CATV systems, instrumentation and test equipment.

Frequency synthesisers form the basis of most radio designs and their performance largely affects the operation of the overall system. The leading requirements for signal-generating components in today's communications equipment include minimised phase noise and broadband frequency coverage.

To address these requirements, the STW81103 claims the industry's best phase-noise performance for single-chip RF synthesisers, with measured values of 0,27° RMS at 1,16 GHz, 0,6° RMS at 2,33 GHz, and 1,5° RMS at 4,67 GHz with a frequency step of 200 kHz. Outstanding suppression of random frequency fluctuations in a signal provides more design margin and the low phase noise also satisfies the stringent requirements of system manufacturers for minimised bit-error rates in voice and data transmission.

In addition to broad spectrum coverage of up to 5 GHz, the STW81103's embedded VCOs with automatic centre-frequency calibration provide outstanding multiband functionality. A single device spans frequency bands from 625 to 762,5 MHz, 1087,5 to 1525 MHz, 2175 to 3050 MHz and 4350 to 5000 MHz, allowing wireless system suppliers to use the device in wideband and multiband applications.





Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Full sensor to cloud solution
CST Electronics Telecoms, Datacoms, Wireless, IoT
NeoCortec has demonstrated the seamless and rapid development of full sensor-to-cloud solutions using NeoMesh Click boards from MikroE and the IoTConnect cloud solution from Avnet.

Read more...
Long-range Wi-Fi HaLow module
TRX Electronics Telecoms, Datacoms, Wireless, IoT
One of Mouser’s newest products is the Morse Micro MM6108-MF08651-US Wi-Fi HaLow Module, which adheres to the IEEE 802.11ah standard.

Read more...
Quectel launches 3GPP NTN comms module
Quectel Wireless Solutions Telecoms, Datacoms, Wireless, IoT
Quectel Wireless Solutions has announced the Quectel BG95-S5 3GPP non-terrestrial network (NTN) satellite communication module.

Read more...
SIMCom’s A7673x series
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat.1 bis module based on the ASR1606 chipset, that supports wireless communication modes of LTE-FDD, with a maximum downlink rate of 10 Mbps and a maximum uplink rate of 5 Mbps.

Read more...
Accelerating the commercialisation of the 5G IoT markets
Altron Arrow Editor's Choice Telecoms, Datacoms, Wireless, IoT
Fibocom unveils Non-Terrestrial Networks (NTN) module MA510-GL, enabling satellite and cellular connectivity to IoT applications.

Read more...
Long-range connectivity module
Avnet Silica Telecoms, Datacoms, Wireless, IoT
Digi XBee XR 868 RF Modules support the deployment of long-range connectivity applications, and support point-to-point and mesh networking protocols.

Read more...
4G LTE-M/NB-IoT connectivity reference design
iCorp Technologies Telecoms, Datacoms, Wireless, IoT
Developed around the industry-leading Nordic nRF9160 module, the platform comes complete with a newly-developed LTE antenna, ATRIA, which is pre-certified to operate over the full LTE-M and NB-IoT bands.

Read more...
Antennas to meet all connectivity requirements
Electrocomp Telecoms, Datacoms, Wireless, IoT
Kyocera AVX RF antennas meet today’s connectivity demands in the LTE, Wi-Fi, Bluetooth, GNSS, and ISM wireless bands, available in surface mount, patch or external configurations.

Read more...
Introducing SIMCom’s new A7673X series
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat 1 bis module that supports LTE-FDD, with a maximum downlink rate of 10 Mbps and an uplink rate of 5 Mbps.

Read more...
18 W monolithic microwave amplifier
RFiber Solutions Telecoms, Datacoms, Wireless, IoT
The CHA8612-QDB is a two stage, high-power amplifier operating between 7,9 and 11 GHz. The monolithic microwave amplifier can typically provide 18 W of saturated output power and 40% of power-added efficiency.

Read more...