Telecoms, Datacoms, Wireless, IoT


Bus transceiver eliminates signal-isolation problems

6 February 2008 Telecoms, Datacoms, Wireless, IoT

The new DS3690 from Maxim is a 3,3 V, bidirectional CMOS transmission gate.

Providing 26 independent channels that can be used for input, output, or I/O signal applications, this device is said to eliminate the signal-isolation problems associated with standard bus transceivers, and save both cost and board space in applications such as point-of-sale terminals, PIN pads, and cryptographic processors in which a downstream component must be isolated from an address or data bus in a timely manner.

Each of the channels consists of two pins. Because each channel is bidirectional, either of its pins can be used as the input pin for a unidirectional signal. A change in logic state on any one side of the channel is directly reflected on the opposite side of that channel.

Packaged in a lead-free, 5 mm x 11 mm x 0,8 mm, 56-pin TQFN, the DS3690 is fully specified over the -55°C to +85°C temperature range.

For more information contact CST Electronics, +27 (0)11 608 0070, [email protected], www.cstelectronics.co.za



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

Full sensor to cloud solution
CST Electronics Telecoms, Datacoms, Wireless, IoT
NeoCortec has demonstrated the seamless and rapid development of full sensor-to-cloud solutions using NeoMesh Click boards from MikroE and the IoTConnect cloud solution from Avnet.

Read more...
Long-range Wi-Fi HaLow module
TRX Electronics Telecoms, Datacoms, Wireless, IoT
One of Mouser’s newest products is the Morse Micro MM6108-MF08651-US Wi-Fi HaLow Module, which adheres to the IEEE 802.11ah standard.

Read more...
Quectel launches 3GPP NTN comms module
Quectel Wireless Solutions Telecoms, Datacoms, Wireless, IoT
Quectel Wireless Solutions has announced the Quectel BG95-S5 3GPP non-terrestrial network (NTN) satellite communication module.

Read more...
SIMCom’s A7673x series
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat.1 bis module based on the ASR1606 chipset, that supports wireless communication modes of LTE-FDD, with a maximum downlink rate of 10 Mbps and a maximum uplink rate of 5 Mbps.

Read more...
Accelerating the commercialisation of the 5G IoT markets
Altron Arrow Editor's Choice Telecoms, Datacoms, Wireless, IoT
Fibocom unveils Non-Terrestrial Networks (NTN) module MA510-GL, enabling satellite and cellular connectivity to IoT applications.

Read more...
Banana Pi with NPU
CST Electronics AI & ML
The latest Banana Pi SBC, the BPI-M7, is powered by Rockchip’s latest flagship RK3588 octa-core 64-bit processor, with a maximum frequency of 2,4 GHz.

Read more...
Long-range connectivity module
Avnet Silica Telecoms, Datacoms, Wireless, IoT
Digi XBee XR 868 RF Modules support the deployment of long-range connectivity applications, and support point-to-point and mesh networking protocols.

Read more...
4G LTE-M/NB-IoT connectivity reference design
iCorp Technologies Telecoms, Datacoms, Wireless, IoT
Developed around the industry-leading Nordic nRF9160 module, the platform comes complete with a newly-developed LTE antenna, ATRIA, which is pre-certified to operate over the full LTE-M and NB-IoT bands.

Read more...
Antennas to meet all connectivity requirements
Electrocomp Telecoms, Datacoms, Wireless, IoT
Kyocera AVX RF antennas meet today’s connectivity demands in the LTE, Wi-Fi, Bluetooth, GNSS, and ISM wireless bands, available in surface mount, patch or external configurations.

Read more...
Introducing SIMCom’s new A7673X series
Otto Wireless Solutions Telecoms, Datacoms, Wireless, IoT
SIMCom recently released the A7673X series, a Cat 1 bis module that supports LTE-FDD, with a maximum downlink rate of 10 Mbps and an uplink rate of 5 Mbps.

Read more...