Analogue, Mixed Signal, LSI


Digital step attenuator

13 July 2016 Analogue, Mixed Signal, LSI

Mini Circuits announced the latest addition to its surface mount digital attenuator range, the DAT-31R5A+ series. This attenuator is packed in a small DG983-2 case style, measuring only 4 x 4 mm.

The wideband device operates up to 4 GHz and is designed to be immune to latchup. It boasts a high IP3 of 52 dBm and provides adjustable attenuation from 0 to 31,5 dB in 0,5 dB steps. The control is a 6-bit serial/parallel interface, and the attenuator operates with either a single positive or dual (positive and negative) supply voltage.

The DAT-31R5A+ series has accuracy of 0,1 dB and a very fast switching control frequency of up to 1 MHz through its parallel control interface.

For more information contact Conical Technologies, +27 (0)12 347 5035, [email protected], www.conical.co.za



Credit(s)



Share this article:
Share via emailShare via LinkedInPrint this page

Further reading:

AC-DC brick PSU
Conical Technologies Power Electronics / Power Management
These PSUs have a typical efficiency of up to 92%, and a power factor value of up to 0,99. They are available in 12, 24, 28, 48 and 54 V output versions.

Read more...
5 kW switching PSU range
Conical Technologies Power Electronics / Power Management
Mornsun has released a new switching power supply range, the LMF5000-25Bxx, which has a 5000 W capacity, and features universal AC input configurations.

Read more...
Parallel redundancy power module
Conical Technologies Power Electronics / Power Management
The LIR40-40 is a wide input range DC-DC module, with a constant output of 48 V at a nominal output current of up to 40 A.

Read more...
Multi-channel electronic load series
Conical Technologies Power Electronics / Power Management
ITECH has recently announced the release of their upgraded IT8700P+ series multi-channel electronic loads. This new series supports master-slave parallel configuration between all the modules, allowing for different modules to be mixed and matched for synchronisation.

Read more...
PV DC-DC converter
Conical Technologies Power Electronics / Power Management
This new series from Mornsun is designed for renewable energy applications, and boasts an ultra-wide and ultra-high 300 to 1500 V DC.

Read more...
High-voltage PSUs for optic applications
Conical Technologies Power Electronics / Power Management
For all applications in electronic optics, it is crucial to have a reliable power supply or capacitor charger, with high precision, stability, and efficiency.

Read more...
High-speed PIN diode
Altron Arrow Analogue, Mixed Signal, LSI
Vishay’s new high-speed Silicon PIN diode is able to detect both visible and near infra-red radiation over a wide spectrum range from 350 to 1100 nm.

Read more...
DC/DC converters with ultra-wide input range
Conical Technologies Power Electronics / Power Management
The THN 15UIR and THN 20UIR series from Traco are high-performance DC/DC converters with an ultra-wide 12:1 input voltage range and a power output of 15 and 20 W respectively.

Read more...
Analogue front end for sensor measurements
Electrocomp Analogue, Mixed Signal, LSI
The NJU9103 AFE from Nisshinbo is a tiny analogue front end, with a 16-bit resolution ADC and up to 512 x signal amplification from the programmable gain amplifier.

Read more...
Graphical source measure unit
Conical Technologies Test & Measurement
The IT2800 Series from ITECH are compact and cost-effective bench-top source measure units with the capability to source and measure both voltage and current.

Read more...