Altron Arrow

Tel: +27 11 923 9600
Email: [email protected]
www: www.altronarrow.com
more information about Altron Arrow

Highly stable thin-film flat chip resistors
1 November 2006, Passive Components

Vishay's new TNPW e3 series of high-stability thin-film flat chip resistors comes in seven industry-standard sizes. These thin-film flat chip resistors are optimised for modern electronics applications ...
read more


ESD protection with ultra-low capacitance for high bandwidth applications
1 November 2006, Circuit & System Protection

The next generation of computer and consumer products will use data serialisation at much higher transmissions speeds. Protection against electrostatic discharge (ESD) is vital for such products. Protection ...
read more


Cable plugs for rugged fine pitch interface applications
1 November 2006, Interconnection

Samtec Tiger Eye contacts are used in new Micro Mate discrete wire cable plugs (SFSD Series) to provide cable-to-board solutions for the popular TFM/SFM Series board-to-board interconnect system. These ...
read more


Range of Simholders and connectors for cellphones
1 November 2006, Interconnection

Amphenol has released a whole new range of mobile phone peripherals including Simholders, Simblocks as well as pogo pins, and battery and I/O connectors. The Simholders range from lockable hinge types, ...
read more


Streamlined 16-bit MCU family targets automotive applications
1 November 2006, EBV Electrolink, DSP, Micros & Memory

Freescale's 16-bit microcontroller S12X family is optimised for a broad range of cost-sensitive automotive body electronics applications. The family includes six devices for flexibility in choosing different ...
read more


Enhanced version of PSoC design tool released
18 October 2006, Design Automation

Cypress Semiconductor has introduced Version 2.1 of PSoC Express, the innovative development tool for PSoC (programmable system on chip) mixed-signal arrays that simplifies embedded design. The new release ...
read more


What to consider when choosing a hot-swap controller IC
18 October 2006, EBV Electrolink, Power Electronics / Power Management

Inserting or removing a circuit board from a live backplane can cause damaging transients unless appropriate design considerations are taken. ITraditional solutions have used an integrated circuit (IC) ...
read more


LDO regulator has unique features
18 October 2006, Tempe Technologies, Electrocomp, Power Electronics / Power Management

Microchip has introduced what it says is the industry’s first 1,5 A LDO that incorporates shutdown, power good, programmable power good delay and bond-wire compensation on a single chip. The MCP1727 ...
read more


Reset switch the answer for pump manufacture
18 October 2006, Switches, Relays & Keypads

The majority of waste water, condensation, and submersible pumps use a float (or safety) switch to detect the water level. This device switches off the pump when water level is at the desired state. These ...
read more


Monolithic crystal filters are compact but hardy
18 October 2006, Passive Components

KDK's monolithic crystal filters (MCF) are available in a wide frequency range for receiving and transmitting applications. Some applications include: cellular radios, miniature pagers, synchronised multiplexers ...
read more


MIL-C-38999 connectors for harsh environments
18 October 2006, Interconnection

Amphenol’s MIL-C-38999 ­connectors are designed and approved to meet most stringent requirements of the military and aerospace industry. Within the connector range, Amphenol produces four series of ...
read more


8-bit MCU eliminates need for external ADC in sensor designs
18 October 2006, Electrocomp, Tempe Technologies, DSP, Micros & Memory

The four-member PIC18F4523 family is Microchip Technology's first family of high-end 8-bit Flash microcontrollers to include a high-speed 12-bit analog-to-digital converter (ADC) peripheral on-chip. It ...
read more





<< First   < Previous   Page 170 of 229   Next >   Last >>







While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved